11730D AGILENT TECHNOLOGIES, 11730D Datasheet - Page 131

• Manufacturer Part Number: 11730D
• Description: SENSOR CABLE, 50FT
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 11730D

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Cable Length: 50ft
• Features: Reduces RFI Effect On Low Power Readings With Improved Shielding Design
• Cable Assembly Type: Sensor
• Cable Color: Gray
• Rohs Compliant: No
• For Use With: 8480 & E-Series Power Sensors
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

120
15
Switches
High Performance Transfer Switch
Applications
The Agilent 87222C/D/E transfer switches can be used in many
different applications to increase system flexibility and simplify
system design. The following are five examples: switch between
two inputs and two outputs, use as a drop-out switch, use for
signal reversal, configure as a SPDT switch, and bypass an
active device.
The Agilent 87222C/D/E transfer switches have the ability to
exchange two signals between two inputs and two outputs. The
transfer switches can connect two different instruments with two
devices under test (DUT). Once switched, the signals are
exchanged between the two instruments and the two DUTs. The
exchanged signals allow complete network and spectrum analysis
on two devices with a single switch and one test setup. See
Figure 1 for an example of this application.
Figure 1. Switching two instruments and two DUTs
The Agilent 8782C/D/E can be used as a simple drop-out switch
where a signal is either run through the device under test or
straight through the switch, bypassing the device. See Figure 3.
Figure 3. Drop-out switch
Spectrum
1
analyzer
DUT 1
2
Filter CONNECTED
Position A
Spectrum
Network
analyzer
analyzer
Position A
Position B
DUT 1
Filter BYPASSED
Position B
Position A
Position B
DUT 2
Filter
DUT 2
1
Network
analyzer
2
In the signal reverse configuration, a device can be connected
across two diagonal ports of the Agilent 87222C/D/E transfer
switch. This will allow the signal direction through the device to
be reversed. See Figure 2.
Figure 2. Signal reversal
By attaching an external termination, the designer can use the
Agilent 87222C/D/E in a SPDT terminated switch configuration.
See Figure 4.
Figure 4. SPDT terminated
IN port 1, OUT port 3
Port 1 to 2 through
Port 4 terminated
Position A
Position A
IN port 3, OUT port 1
Port 1 to 4 through
Port 2 terminated
Position B
Position B
50 Ohm
load