XC3S1600E-5FG320C Xilinx Inc, XC3S1600E-5FG320C Datasheet - Page 89

• Manufacturer Part Number: XC3S1600E-5FG320C
• Description: PROGRAMMABLE MICROCHIP
• Manufacturer: Xilinx Inc

Functional Description
Table 55: Slave Parallel Mode Connections (Continued)
Voltage Compatibility
FPGA’s I/O Bank 2, supplied by the VCCO_2 supply input.
The VCCO_2 voltage can be 1.8V, 2.5V, or 3.3V to match
the requirements of the external host, ideally 2.5V. Using
1.8V or 3.3V requires additional design considerations as
the DONE and PROG_B pins are powered by the FPGA’s
2.5V VCCAUX supply. See application note XAPP453: "The
3.3V Configuration of Spartan-3 FPGAs" for additional infor-
mation.
The LDC[2:0] and HDC signal are active in I/O Bank 1 but
are not used in the interface. Consequently, VCCO_1 can
be set the appropriate voltage for the application.
82
CSO_B
INIT_B
DONE
PROG_B
V
Pin Name
Most Slave Parallel interface signals are within the
FPGA Direction
bidirectional I/O
bidirectional I/O
Open-drain
Open-drain
Output
Input
Chip Select Output. Active Low.
Initialization Indicator. Active Low.
Goes Low at start of configuration
during Initialization memory
clearing process. Released at end
of memory clearing, when mode
select pins are sampled. In
daisy-chain applications, this signal
requires an external 4.7 kΩ pull-up
resistor to VCCO_2.
FPGA Configuration Done. Low
during configuration. Goes High
when FPGA successfully
completes configuration. Requires
external 330 Ω pull-up resistor to
2.5V.
Program FPGA. Active Low. When
asserted Low for 300 ns or longer,
forces the FPGA to restart its
configuration process by clearing
configuration memory and resetting
the DONE and INIT_B pins once
PROG_B returns High. Requires
external 4.7 kΩ pull-up resistor to
2.5V. If driving externally, use an
open-drain or open-collector driver.
Description
www.xilinx.com
Daisy-Chaining
If the application requires multiple FPGAs with different con-
figurations, then configure the FPGAs using a daisy chain.
Use Slave Parallel mode (M[2:0] = <1:1:0>) for all FPGAs in
the daisy-chain. The schematic in
FPGA downloading and does not support the SelectMAP
read interface. The FPGA’s RDWR_B pin must be Low dur-
ing configuration.
After the lead FPGA is filled with its configuration data, the
lead FPGA enables the next FPGA in the daisy-chain by
asserting is chip-select output, CSO_B.
Not used in single FPGA
applications. In a daisy-chain
configuration, this pin connects
to the CSI_B pin of the next
FPGA in the chain. Actively
drives.
Active during configuration. If
CRC error detected during
configuration, FPGA drives
INIT_B Low.
Low indicates that the FPGA is
not yet configured.
Must be High to allow
configuration to start.
During Configuration
Advance Product Specification
DS312-2 (v1.1) March 21, 2005
Figure 59
User I/O
User I/O
Pulled High via external
pull-up. When High,
indicates that the FPGA
successfully configured.
Drive PROG_B Low and
release to reprogram
FPGA.
After Configuration
is optimized for
R