RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 26

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

Figure 1-3. Typical PMC Module Placement on an MVME5100
Primary PMCspan
8
1 Hardware Preparation and Installation
MVME51005E Single Board Computer Installation and Use (6806800A38B)
To install a PMCspan16E-002 PCI expansion module on your MVME5100, perform the
following steps while referring to the figure on the next page:
Note
Warning
Caution
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
3. If the MVME5100 has already been installed in a VMEbus card slot, carefully remove
4. Attach the four standoffs to the MVME5100. For each standoff:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
This procedure assumes that you have read the user’s manual that was furnished with
your PMCspan and that you have installed the selected PMC modules on to your
PMCspan according to the instructions provided in the PMCspan and PMC manuals.
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME modules.
it as shown in
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing, and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
Figure 1-2
and place it with connectors P1 and P2 facing you.