RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 30

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

12
1 Hardware Preparation and Installation
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Note
Note
4. Slide the MVME5100 (and PMCspans if used) into the selected card slot(s). Verify that
5. Secure the MVME5100 (and PMCspans if used) in the chassis with the screws in the
6. On the chassis backplane, remove the
7. If you intend to use PPCbug interactively, connect the terminal that is to be used as the
8. Replace the chassis or system cover(s) and cable peripherals to the panel connectors
9. Reconnect the system to the AC or DC power source and turn the system power on.
10. The MVME5100’s green
the module or module(s) seated properly in the P1 and P2 connectors on the chassis
backplane. Do not damage or bend connector pins.
top and bottom of its front panel and verify proper contact with the transverse mounting
rails to minimize RF emissions.
Some VME backplanes (such as those used in Emerson Modular Chassis systems)
have an auto-jumpering feature for automatic propagation of the IACK and BG signals.
The step immediately below does not apply to such backplane designs.
GRANT
and any PMCspan modules.
PPCbug system console to the
In normal operation, the host CPU controls MVME5100 operation via the VMEbus
Universe registers.
as required.
and the debugger prompt
(BG) jumpers from the header for the card slots occupied by the MVME5100
– If you do not intend to use the MVME5100 as system controller, it can
occupy any unused card slot.
CPU
PPC6-Bug>
LED indicates activity as a set of confidence tests is run,
DEBUG
appears.
INTERRUPT ACKNOWLEDGE
port on the front panel of the MVME5100.
(IACK) and
BUS