RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 64

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

Host Clock Logic
RAM500 Module Installation
Figure 5-2. RAM500 Module Placement on MVME5100
46
5 RAM500 Memory Expansion Module
MVME51005E Single Board Computer Installation and Use (6806800A38B)
The host board provides four SDRAM clocks to the memory expansion connector. The
frequency of the RAM500 CLKS is the same as the host board.
One or more RAM500 memory expansion modules can be mounted on top of the MVME5100
for additional memory capacity. To upgrade or install a RAM500 module, refer to
proceed as follows:
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
3. Carefully remove the MVME5100 from its VME card slot and lay it flat, with connectors
4. Inspect the RAM500 module that is being installed on the MVME5100 host board
5. With standoffs installed in the three mounting holes on the RAM500 module, align the
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis
as a ground. The ESD strap must be secured to your wrist and to ground throughout
the procedure.
AC cord or DC power lines from the system. Remove the chassis or system cover(s)
as necessary for access to the CompactPCI boards.
P1 and P2 facing you.
(bottom configuration if two are being installed, top configuration if only one is being
installed) to ensure that standoffs are installed in the three mounting holes on the
module.
standoffs and the P1 connector on the module with the three holes and the J16
connector on the MVME5100 host board and press the two connectors together until
they are firmly seated in place.
Figure 5-2
and