RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 32

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

Status Indicators
Connectors
14
2 Operation
RST Indicator (DS1)
CPU Indicator (DS2)
10/100BASE T Ports
DEBUG Port
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Note
There are two Light-Emitting Diode (LED) status indicators located on the MVME5100 front
panel. They are labeled
The yellow
LED test. The
MVME5100 Single Board Computer Programmer’s Reference Guide (V5100A/PG) for
information on these registers.
The green
There are three connectors on the front panel of the MVME5100. Two are bottom-labeled
10/100BASE T
The two RJ-45 ports labeled
interface. These connectors are top-labeled with the designation
The RJ-45 port labeled
TL16C550 Universal Asynchronous Receiver/Transmitter (UART) controller chip. It is
asynchronous only. For additional information on pin assignments, refer to
Assignments.
The
firmware console for the factory installed debugger, PPCBug. The port is configured as follows:
After power-up, the baud rate of the
Port Format (PF) command.
DEBUG
SYSRESET# remains asserted for at least 200 ms, as required by the VMEbus
specification.
❏
❏
❏
❏
CPU
BFL
port may be used for connecting a terminal to the MVME5100 to serve as the
8 bits per character
1 stop bit per character
Parity disabled (no parity)
Baud rate = 9600 baud (default baud rate at power-up)
and one is labeled
BFL
LED indicates board failure; this indicator is also illuminated during reset as an
LED indicates CPU activity.
is set if the MODFAIL Register or FUSE Register is set. Refer to the
DEBUG
BFL
and
10/100BASE T
provides an RS232 serial communications interface, based on
CPU
DEBUG
DEBUG
.
.
provide the 10BASE T/100BASE TX Ethernet LAN
port can be reconfigured by using the debugger’s
LAN1
and
Chapter 6, Pin
LAN2
.