ISP1109BS,118 NXP Semiconductors, ISP1109BS,118 Datasheet - Page 13

• Manufacturer Part Number: ISP1109BS,118
• Description: RF Transceiver USB FS TRANSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1109BS,118

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Triple
• Operating Supply Voltage (typ): Not RequiredV
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): Not RequiredV
• Operating Supply Voltage (min): Not RequiredV
• Pin Count: 32
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Operating Supply Voltage: 1.65 V to 5.25 V
• Lead Free Status / RoHS Status: Compliant
• Other names: 935276024118 ISP1109BS-T

Philips Semiconductors
9397 750 13355
Product data sheet
7.9.1 Differential driver
7.9 USB transceiver
Pin ISET will remain LOW when V
software through register bits. If bit ISET_DRV_EN is set to logic 1, the status of the ISET
pin will be determined by bit ISET_STATE.
The operation of the driver is described in
Table 6:
[1]
Table 7
Table 7:
Pin
RESET_N
HIGH
HIGH
HIGH
HIGH
LOW
USB mode
DAT_SE0
DAT_SE0
DAT_SE0
DAT_SE0
VP_VM
•
If the Power-down is because of the setting of register bit PWR_DN in the Mode
Control register, the bias will be enabled if the V
SESS_VLD threshold. Note: In this case, make sure bit SESS_VLD_IEH in the
Interrupt Enable High register is set to logic 1 before the PWR_DN bit is set. The
recommended sequences for software is:
a. Set bit SESS_VLD_IEH to logic 1
b. Set bit PWR_DN to logic 1
c. Wait for interrupt from the ISP1109
d. If INT_N is asserted, read the Interrupt Latch register
e. If bit SESS_VLD_INT is logic 1, clear bit PWR_DN (Note: Software must clear
Include the internal power-on-reset pulse (active HIGH).
bit PWR_DN within 5 ms from the time pin INT_N is asserted. For details,
see
shows the behavior of the transmit operation in detail.
[1]
Transceiver driver operating setting
USB functional mode: transmit operation
Section
OE_N
LOW
LOW
LOW
HIGH
X
Inputs
DAT/VP
LOW
HIGH
LOW
HIGH
LOW
10).
Pin or bit
SUSPEND
0
0
1
X
X
Rev. 01 — 14 July 2005
CC
SE0/VM
LOW
LOW
HIGH
HIGH
LOW
is below V
Bit DAT_SE0
0
1
X
X
X
Table
th(ISET)
6.
USB transceiver with carkit support
BUS
. Pin ISET can also be controlled by
Outputs
DP
LOW
HIGH
LOW
LOW
LOW
Differential driver
output value from DAT/VP to DP and
SE0/VM to DM
output value from DAT/VP to DP and
DM, if SE0/VM is LOW; otherwise,
drive both DP and DM LOW
output value from DAT/VP to DP and
DM
high-Z
high-Z
voltage goes above the
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
DM
HIGH
LOW
LOW
LOW
LOW
ISP1109
12 of 59