BOXD865GLCL Intel, BOXD865GLCL Datasheet - Page 133

• Manufacturer Part Number: BOXD865GLCL
• Manufacturer: Intel

Specifications of BOXD865GLCL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

5 Error Messages and Beep Codes
What This Chapter Contains
5.1 BIOS Error Messages
5.1
5.2
5.3
5.4
5.5
Table 79 lists the error messages and provides a brief description of each.
Table 79.
Error Message
GA20 Error
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
Pri Master Drive - ATAPI Incompatible
Pri Slave Drive - ATAPI Incompatible
Sec Master Drive - ATAPI Incompatible
Sec Slave Drive - ATAPI Incompatible
A: Drive Error
Cache Memory Bad
CMOS Battery Low
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
BIOS Error Messages...............................................................................................133
Port 80h POST Codes..............................................................................................135
Bus Initialization Checkpoints ...................................................................................139
Speaker ....................................................................................................................140
BIOS Beep Codes ....................................................................................................140
BIOS Error Messages
Explanation
An error occurred with Gate A20 when switching to protected
mode during the memory test.
Could not read sector from corresponding drive.
Corresponding drive in not an ATAPI device. Run Setup to make
sure device is selected correctly.
No response from diskette drive.
An error occurred when testing L2 cache. Cache memory may be
bad.
The battery may be losing power. Replace the battery soon.
The display type is different than what has been stored in CMOS.
Check Setup to make sure type is correct.
The CMOS checksum is incorrect. CMOS memory may have
been corrupted. Run Setup to reset values.
CMOS values are not the same as the last boot. These values
have either been corrupted or the battery has failed.
The time and/or date values stored in CMOS are invalid. Run
Setup to set correct values.
Error during read/write test of DMA controller.
Error occurred trying to access diskette drive controller.
Error occurred trying to access hard disk controller.
continued
133