BOXD865GLCL Intel, BOXD865GLCL Datasheet - Page 40

• Manufacturer Part Number: BOXD865GLCL
• Manufacturer: Intel

Specifications of BOXD865GLCL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Intel Desktop Board D865GBF/D865GLC Technical Product Specification
1.8.4.2
40
ATA-66 and ATA-100 are faster timings and require a specialized cable to reduce reflections,
noise, and inductive coupling.
The Parallel ATA IDE interfaces also support ATAPI devices (such as CD-ROM drives) and ATA
devices using the transfer modes listed in Section 4.4.4.1 on page 116.
The BIOS supports Logical Block Addressing (LBA) and Extended Cylinder Head Sector (ECHS)
translation modes. The drive reports the transfer rate and translation mode to the BIOS.
The Desktop Boards support Laser Servo (LS-120) diskette technology through the Parallel ATA
IDE interfaces. An LS-120 drive can be configured as a boot device by setting the BIOS Setup
program’s Boot menu to one of the following:
The ICH5’s Serial ATA controller offers two independent Serial ATA ports with a theoretical
maximum transfer rate of 150 MB/s per port. One device can be installed on each port for a
maximum of two Serial ATA devices. A point-to-point interface is used for host to device
connections, unlike Parallel ATA IDE which supports a master/slave configuration and two
devices per channel.
For compatibility, the underlying Serial ATA functionality is transparent to the operating system.
The Serial ATA controller can operate in both legacy and native modes. In legacy mode, standard
IDE I/O and IRQ resources are assigned (IRQ 14 and 15). In Native mode, standard PCI resource
steering is used. Native mode is the preferred mode for configurations using the Windows XP and
Windows 2000 operating systems.
NOTE
Many Serial ATA drives use new low-voltage power connectors and require adaptors or power
supplies equipped with low-voltage power connectors.
For more information, see:
NOTE
For information about
The location of the Parallel ATA IDE connectors on the D865GLC board
The location of the Parallel ATA IDE connectors on the D865GBF board
ARMD-FDD (ATAPI removable media device – floppy disk drive)
ARMD-HDD (ATAPI removable media device – hard disk drive)
Serial ATA Interfaces
http://www.serialata.org/
Refer to
Figure 21, page 76
Figure 22, page 77