BOXD865GLCL Intel, BOXD865GLCL Datasheet - Page 81

• Manufacturer Part Number: BOXD865GLCL
• Manufacturer: Intel

Specifications of BOXD865GLCL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

2.8.3.2.1
2.8.3.2.2
2.8.3.2.3
2.8.3.2.4
Pins 1 and 3 can be connected to an LED to provide a visual indicator that data is being read from
or written to a hard drive. Proper LED function requires one of the following:
Pins 5 and 7 can be connected to a momentary single pole, single throw (SPST) type switch that is
normally open. When the switch is closed, the board resets and runs the POST.
Pins 2 and 4 can be connected to a one- or two-color LED. Table 39 shows the possible states for
a one-color LED. Table 40 shows the possible states for a two-color LED.
Table 39.
Table 40.
To use the message waiting function, ACPI must be enabled in the operating system and a
message-capturing application must be invoked.
Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must
pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off.
(The time requirement is due to internal debounce circuitry on the board.) At least two seconds
must pass before the power supply will recognize another on/off signal.
NOTE
LED State
Off
Steady Green
Blinking Green
LED State
Off
Steady Green
Blinking Green
Steady Yellow
Blinking Yellow
A Serial ATA hard drive connected to an onboard Serial ATA connector
A Parallel ATA IDE hard drive connected to an onboard Parallel ATA IDE connector
Hard Drive Activity LED Connector
Reset Switch Connector
Power/Sleep/Message Waiting LED Connector
Power Switch Connector
States for a One-Color Power LED
States for a Two-Color Power LED
Description
Power off/sleeping
Running
Running/message waiting
Description
Power off
Running
Running/message waiting
Sleeping
Sleeping/message waiting
Technical Reference
81