XC56309AG100A Freescale Semiconductor, XC56309AG100A Datasheet - Page 113

• Manufacturer Part Number: XC56309AG100A
• Description: IC DSP 24BIT 100MHZ 144-TQFP
• Manufacturer: Freescale Semiconductor
• Series: DSP563xxr
• Type: Fixed Pointr

Specifications of XC56309AG100A

• Interface: Host Interface, SSI, SCI
• Clock Rate: 100MHz
• Non-volatile Memory: ROM (576 B)
• On-chip Ram: 24kB
• Voltage - I/o: 3.30V
• Voltage - Core: 3.30V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.6.2 Host Status Register (HSR)
The HSR is a 16-bit read-only status register by which the DSP reads the HI08 status and flags.
The host processor cannot access it directly. The initialization values for the HSR bits are
discussed in Section 6.6.9, DSP-Side Registers After Reset, on page 6-20.
Freescale Semiconductor
Bit Number
Bit Number
15–5
2
1
0
15
—Reserved bit; read as 0; write to 0 for future compatibility.
14
Bit Name
Bit Name
HCIE
HTIE
HRIE
13
Table 6-8. Host Control Register (HCR) Bit Definitions
Figure 6-7. Host Status Register (HSR) (X:$FFFFC3)
Table 6-9. Host Status Register (HSR) Bit Definitions
12
Reset Value
Reset Value
11
0
0
0
0
10
DSP56309 User’s Manual, Rev. 1
Host Command Interrupt Enable
Generates a host command interrupt request if the host command pending
(HCP) status bit in the HSR is set. If HCIE is cleared, HCP interrupts are
disabled. The interrupt address is determined by the host command vector
register (CVR).
NOTE: If more than one interrupt request source is asserted and enabled
(for example, HRDF is set, HCP is set, HRIE is set, and HCIE is set), the
HI08 generates interrupt requests according to priorities shown here. The bit
value is indeterminate after an individual reset.
Host Transmit Interrupt Enable
Generates a host transmit data interrupt request if the host transmit data
empty (HTDE) bit in the HSR is set. The HTDE bit is set when data is
transferred from the HTX to the RXH, RXM, or RXL registers. If HTIE is
cleared, HTDE interrupts are disabled. The bit value is indeterminate after
an individual reset.
Host Receive Interrupt Enable
Generates a host receive data interrupt request if the host receive data full
(HRDF) bit in the host status register (HSR, Bit 0) is set. The HRDF bit is set
when data is transferred to the HRX from the TXH, TXM, or TXL registers. If
HRIE is cleared, HRDF interrupts are disabled. The bit value is
indeterminate after an individual reset.
Reserved. Write to 0 for future compatibility.
9
8
Priority
Highest
Lowest
7
6
5
Description
Description
HF1
4
Host Command (HCP = 1)
Transmit Data (HTDE = 1)
Receive Data (HRDF = 1)
HF0
DSP Core Programming Model
3
Interrupt Source
HCP HTDE HRDF
2
1
0
6-13