ADAU1381BCPZ Analog Devices Inc, ADAU1381BCPZ Datasheet - Page 40

• Manufacturer Part Number: ADAU1381BCPZ
• Description: IC AUDIO CODEC STEREO LN 32LFCSP
• Manufacturer: Analog Devices Inc
• Type: Stereo Audior

Specifications of ADAU1381BCPZ

• Data Interface: Serial, SPI™
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 2
• Sigma Delta: No
• S/n Ratio, Adcs / Dacs (db) Typ: 97 / 100
• Dynamic Range, Adcs / Dacs (db) Typ: 96.5 / 100
• Voltage - Supply, Analog: 1.8 V ~ 3.65 V
• Voltage - Supply, Digital: 1.63 V ~ 3.65 V
• Operating Temperature: -25°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 32-VFQFN, CSP Exposed Pad
• Audio Codec Type: Stereo
• No. Of Adcs: 2
• No. Of Dacs: 2
• No. Of Input Channels: 3
• No. Of Output Channels: 3
• Adc / Dac Resolution: 24bit
• Adcs / Dacs Signal To Noise Ratio: 100dB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ADAU1381
GENERAL-PURPOSE INPUT/OUTPUTS
The serial data input/output pins are shared with the general-
purpose input/output function. Each of these four pins can be
set to only one function. The function of these pins is set in
Register 16628 (0x40F4), serial data/GPIO pin configuration.
The GPIO pins can be used as either inputs or outputs. These pins
are readable and can be set either through the control interface
or directly by the sound engine. When set as inputs, these pins
can be used with push-button switches or rotary encoders to
control sound engine program settings. Digital outputs can be
used to drive LEDs or external logic to indicate the status of
internal signals and control other devices. Examples of this use
include indicating signal overload, signal present, and button
press confirmation.
When set as an output, each pin can typically drive 2 mA. This
is enough current to directly drive some high efficiency LEDs.
Standard LEDs require about 20 mA of current and can be driven
Rev. B | Page 40 of 84
from a GPIO output with an external transistor or buffer. Because
of issues that may arise from simultaneously driving or sinking a
large current on many pins, care should be taken in the application
design to avoid connecting high efficiency LEDs directly to many
or all of the GPIO pins. If many LEDs are required, use an external
driver. When the GPIO pins are set as open-collector outputs,
they should be pulled up to a maximum voltage of what is set
on IOVDD.
The configuration of the GPIO functions is set up in Register 16582
to Register 16586 (0x40C6 to 0x40CA), GPIO pin control.
GPIOs Set from Control Port
The GPIO pins can also be set to be directly controlled from the
I
memory locations are enabled for the GPIO pin settings (see
Table 69). The physical settings on the GPIO pins mirror the
settings of the LSB of these 4-byte-wide memory locations.
2
C/SPI control port. When the pins are set into this mode, five