FLUKE-190-104/AM Fluke Electronics, FLUKE-190-104/AM Datasheet - Page 69

• Manufacturer Part Number: FLUKE-190-104/AM
• Description: SCOPEMETER 4CH 100MHZ COLOR AMER
• Manufacturer: Fluke Electronics
• Series: ScopeMeter® 190r
• Type: Handheldr

Specifications of FLUKE-190-104/AM

• Bandwidth: 100MHz
• Channels: 4
• Display Type: LCD - Color
• Features: DMM, USB Interface, Save, Recall, Record, Trend
• Probe Type: 10:1 Voltage Probe (1 Blue, 1 Green, 1 Red, 1 Gray)
• Sampling Rate (per Second): 1.25GS/s
• Input Impedance: 1M
• Rise Time (typ): 3.5nS
• Voltage - Input (max): CAT III 1000V, CAT IV 600V
• Voltage - Supply: 7.2V Battery, 17.8VDC Adapter
• Includes: Alligator Clips, Battery Charger/Adapter, Case, Hook Clips, Probe Set, Software, Test Leads, USB Cable
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 614-1176

Triggering on Edges
If the signal is unstable or has a very low frequency, use
edge triggering to obtain full manual trigger control.
To trigger on rising edges of the input A waveform, do the
following:
1
2
3
F4
TRIGGER
ENTER
Display the
Open the
Open the
TRIGGER OPTIONS
TRIGGER ON EDGE
TRIGGER
key labels.
menu.
menu.
When Free Run is selected, the test tool updates the
screen even if there are no triggers. A trace always
appears on the screen.
When On Trigger is selected, the test tool needs a trigger
to display a waveform. Use this mode if you want to
update the screen only when valid triggers occur.
When Single Shot is selected, the test tool waits for a
trigger. After receiving a trigger, the waveform is displayed
and the instrument is set to HOLD.
In most cases it is advised to use the Free Run mode:
Observe that the key labels at the bottom of the screen
have adapted to allow further selection of specific edge
trigger settings:
4
5
ENTER
ENTER
Select Free Run, jump to Trigger
Filter.
Set Trigger Filter to Off.
Triggering on Edges
61