MC68HC811E2FN Freescale Semiconductor, MC68HC811E2FN Datasheet - Page 112

• Manufacturer Part Number: MC68HC811E2FN
• Manufacturer: Freescale Semiconductor

Specifications of MC68HC811E2FN

• Cpu Family: HC11
• Device Core Size: 8b
• Frequency (max): 4MHz
• Interface Type: SCI/SPI
• Program Memory Type: ROMLess
• Program Memory Size: Not Required
• Total Internal Ram Size: 256Byte
• # I/os (max): 38
• Number Of Timers - General Purpose: 8
• Operating Supply Voltage (typ): 3.3/5V
• Operating Supply Voltage (max): 5.5V
• Operating Supply Voltage (min): 3V
• On-chip Adc: 8-chx8-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 52
• Package Type: PLCC
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Serial Communications Interface (SCI)
7.7.4 Serial Communication Status Register
The SCSR provides inputs to the interrupt logic circuits for generation of the SCI system interrupt.
TDRE — Transmit Data Register Empty Flag
TC — Transmit Complete Flag
RDRF — Receive Data Register Full Flag
IDLE — Idle Line Detected Flag
OR — Overrun Error Flag
NF — Noise Error Flag
112
This flag is set when SCDR is empty. Clear the TDRE flag by reading SCSR with TDRE set and then
writing to SCDR.
This flag is set when the transmitter is idle (no data, preamble, or break transmission in progress).
Clear the TC flag by reading SCSR with TC set and then writing to SCDR.
This flag is set if a received character is ready to be read from SCDR. Clear the RDRF flag by reading
SCSR with RDRF set and then reading SCDR.
This flag is set if the RxD line is idle. Once cleared, IDLE is not set again until the RxD line has been
active and becomes idle again. The IDLE flag is inhibited when RWU = 1. Clear IDLE by reading SCSR
with IDLE set and then reading SCDR.
OR is set if a new character is received before a previously received character is read from SCDR.
Clear the OR flag by reading SCSR with OR set and then reading SCDR.
NF is set if majority sample logic detects anything other than a unanimous decision. Clear NF by
reading SCSR with NF set and then reading SCDR.
0 = SCDR busy
0 = SCDR empty
0 = Transmitter busy
1 = Transmitter idle
0 = SCDR empty
1 = SCDR full
0 = RxD line active
1 = RxD line idle
0 = No overrun
1 = Overrun detected
0 = Unanimous decision
1 = Noise detected
Address:
Reset:
Read:
Write:
Figure 7-6. Serial Communications Status Register (SCSR)
$102E
TDRE
Bit 7
1
= Unimplemented
TC
6
1
M68HC11E Family Data Sheet, Rev. 5.1
RDRF
5
0
IDLE
4
0
OR
3
0
NF
2
0
FE
1
0
Freescale Semiconductor
Bit 0
0