AT32UC3C264C Atmel Corporation, AT32UC3C264C Datasheet - Page 881

• Manufacturer Part Number: AT32UC3C264C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C264C

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 20
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32.6.2.10
32117C–AVR-08/11
RAM management
Endpoint data can be physically allocated anywhere in the embedded RAM. The USBC control-
ler accesses these endpoints directly through the HSB master (built-in DMA).
The USBC controller reads the USBC descriptors to know where each endpoint is located. The
base address of the USBC descriptor (UDESC.UDESCA) needs to be written by the user. The
descriptors can also be allocated anywhere in the embedded RAM.
Before using an endpoint, the user should setup the endpoint address for each bank. Depending
on the direction, the type, and the packet-mode (single or multi-packet), the user should also ini-
tialize the endpoint packet size, and the endpoint control and status fields, so that the USBC
controller does not compute random values from the RAM.
When using an endpoint the user should read the UESTAX.CURRBK field to know which bank
is currently being processed.
• The user may then write a one to the remote wakeup (RMWKUP) bit in UDCON to send an
• When the controller sends the Upstream Resume, the Upstream Resume (UPRSM) interrupt
• RMWKUP is cleared at the end of the transmitting Upstream Resume.
• In case of a rebroadcast resume initiated by the host, the End of Resume (EORSM) interrupt
Upstream Resume to the host initiating the wakeup. This will automatically be done by the
controller after 5ms of inactivity on the USB bus.
is set and SUSP is cleared.
is set when the rebroadcast resume is completed.
AT32UC3C
881