SAM3SD8B Atmel Corporation, SAM3SD8B Datasheet - Page 14

no-image

SAM3SD8B

Manufacturer Part Number
SAM3SD8B
Description
Manufacturer
Atmel Corporation
Datasheets
5. Power Considerations
5.1
5.2
5.3
14
Power Supplies
Voltage Regulator
Typical Powering Schematics
SAM3S8/SD8 Summary
The SAM3S8/SD8 has several types of power supply pins:
The SAM3S8/SD8 embeds a voltage regulator that is managed by the Supply Controller.
This internal regulator is designed to supply the internal core of SAM3S8/SD8. It features two
operating modes:
For adequate input and output power supply decoupling/bypassing, refer to the “Voltage Regula-
tor” section in the “Electrical Characteristics” section of the datasheet.
The SAM3S8/SD8 supports a 1.62V-3.6V single supply mode. The internal regulator input con-
nected to the source and its output feeds VDDCORE.
schematics.
As VDDIN powers the voltage regulator, the ADC, DAC and the analog comparator, when the
user does not want to use the embedded voltage regulator, it can be disabled by software via
the SUPC (note that this is different from Backup mode).
• VDDCORE pins: Power the core, the embedded memories and the peripherals. Voltage
• VDDIO pins: Power the Peripherals I/O lines (Input/Output Buffers), USB transceiver, Backup
• VDDIN pin: Voltage Regulator Input, ADC, DAC and Analog Comparator Power Supply.
• VDDPLL pin: Powers the PLLA, PLLB, the Fast RC and the 3 to 20 MHz oscillator. Voltage
• In Normal mode, the voltage regulator consumes less than 700 µA static current and draws
• In Backup mode, the voltage regulator consumes less than 1 µA while its output (VDDOUT)
ranges from 1.62V to 1.95V.
part, 32 kHz crystal oscillator and oscillator pads. Voltage ranges from 1.62V to 3.6V.
Voltage ranges from 1.8V to 3.6V.
ranges from 1.62V to 1.95V.
80 mA of output current. Internal adaptive biasing adjusts the regulator quiescent current
depending on the required load current. In Wait Mode quiescent current is only 7 µA.
is driven internally to GND. The default output voltage is 1.80V and the start-up time to reach
Normal mode is less than 100 µs.
Figure 5-1
below shows the power
11090AS–ATARM–10-Feb-12

Related parts for SAM3SD8B