LM3S1607 Luminary Micro, Inc, LM3S1607 Datasheet - Page 34

• Manufacturer Part Number: LM3S1607
• Description: Lm3s1607 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

Architectural Overview
1.4.6.3
1.4.7
1.4.7.1
1.4.7.2
1.4.7.3
1.4.7.4
34
ROM
The LM3S1607 microcontroller ships with the Stellaris
preprogrammed in read-only memory (ROM). The Stellaris
software library for controlling on-chip peripherals, and includes a boot-loader capability. The library
performs both peripheral initialization and peripheral control functions, with a choice of polled or
interrupt-driven peripheral support, and takes full advantage of the stellar interrupt performance of
the ARM® Cortex™-M3 core. No special pragmas or custom assembly code prologue/epilogue
functions are required. For applications that require in-field programmability, the royalty-free Stellaris
boot loader included in the Stellaris
support in-field firmware updates.
Additional Features
Memory Map (see page 42)
A memory map lists the location of instructions and data in memory. The memory map for the
LM3S1607 controller can be found in “Memory Map” on page 42. Register addresses are given as
a hexadecimal increment, relative to the module's base address as shown in the memory map.
The ARM® Cortex™-M3 Technical Reference Manual provides further information on the memory
map.
JTAG TAP Controller (see page 48)
The Joint Test Action Group (JTAG) port is an IEEE standard that defines a Test Access Port and
Boundary Scan Architecture for digital integrated circuits and provides a standardized serial interface
for controlling the associated test logic. The TAP, Instruction Register (IR), and Data Registers (DR)
can be used to test the interconnections of assembled printed circuit boards and obtain manufacturing
information on the components. The JTAG Port also provides a means of accessing and controlling
design-for-test features such as I/O pin observation and control, scan testing, and debugging.
The JTAG port is composed of the standard four pins: TCK, TMS, TDI, and TDO. Data is transmitted
serially into the controller on TDI and out of the controller on TDO. The interpretation of this data is
dependent on the current state of the TAP controller. For detailed information on the operation of
the JTAG port and TAP controller, please refer to the IEEE Standard 1149.1-Test Access Port and
Boundary-Scan Architecture.
The Luminary Micro JTAG controller works with the ARM JTAG controller built into the Cortex-M3
core. This is implemented by multiplexing the TDO outputs from both JTAG controllers. ARM JTAG
instructions select the ARM TDO output while Luminary Micro JTAG instructions select the Luminary
Micro TDO outputs. The multiplexer is controlled by the Luminary Micro JTAG controller, which has
comprehensive programming for the ARM, Luminary Micro, and unimplemented JTAG instructions.
System Control and Clocks (see page 60)
System control determines the overall operation of the device. It provides information about the
device, controls the clocking of the device and individual peripherals, and handles reset detection
and reporting.
Hibernation Module (see page 124)
The Hibernation module provides logic to switch power off to the main processor and peripherals,
and to wake on external or time-based events. The Hibernation module includes power-sequencing
logic, a real-time clock with a pair of match registers, low-battery detection circuitry, and interrupt
signalling to the processor. It also includes 64 32-bit words of non-volatile memory that can be used
for saving state during hibernation.
®
Peripheral Driver Library can act as an application loader and
Preliminary
®
family Peripheral Driver Library conveniently
®
Peripheral Driver Library is a royalty-free
June 02, 2008
®