LM3S310 Luminary Micro, Inc, LM3S310 Datasheet - Page 206

• Manufacturer Part Number: LM3S310
• Description: Lm3s310 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

Universal Asynchronous Receivers/Transmitters (UARTs)
206
Write-Only Error Clear (UARTECR) Register
31:8
7:0
Bit
2
1
0
reserved
Name
DATA
BE
PE
FE
Type
WO
WO
RO
RO
RO
Reset
0
0
0
0
0
Preliminary
Description
UART Break Error
This bit is set to 1 when a break condition is detected, indicating
that the received data input was held Low for longer than a full-
word transmission time (defined as start, data, parity, and stop
bits).
This bit is cleared to 0 by a write to UARTECR.
In FIFO mode, this error is associated with the character at the
top of the FIFO. When a break occurs, only one 0 character is
loaded into the FIFO. The next character is only enabled after
the receive data input goes to a 1 (marking state) and the next
valid start bit is received.
UART Parity Error
This bit is set to 1 when the parity of the received data character
does not match the parity defined by bits 2 and 7 of the
UARTLCRH register.
This bit is cleared to 0 by a write to UARTECR.
UART Framing Error
This bit is set to 1 when the received character does not have a
valid stop bit (a valid stop bit is 1).
This bit is cleared to 0 by a write to UARTECR.
In FIFO mode, this error is associated with the character at the
top of the FIFO.
Reserved bits return an indeterminate value, and should never
be changed.
A write to this register of any data clears the framing, parity,
break and overrun flags.
July 5, 2006