pcf2127a NXP Semiconductors, pcf2127a Datasheet - Page 50
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
pcf2127a
Manufacturer Part Number
pcf2127a
Description
Integrated Rtc, Tcxo And Quartz Crystal
Manufacturer
NXP Semiconductors
Datasheet
1.PCF2127A.pdf
(79 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
pcf2127aT
Manufacturer:
NICCOMP
Quantity:
420 000
Part Number:
pcf2127aT
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
pcf2127aT/2
Manufacturer:
NXP
Quantity:
441
NXP Semiconductors
PCF2127A_1
Product data sheet
8.14 External clock test mode
A test mode is available which allows on-board testing. In this mode it is possible to set up
test conditions and control the operation of the RTC.
The test mode is entered by setting bit EXT_TEST logic 1 (register Control_1). Then
pin CLKOUT becomes an input. The test mode replaces the internal clock signal (64 Hz)
with the signal applied to pin CLKOUT. Every 64 positive edges applied to pin CLKOUT
generate an increment of one second.
The signal applied to pin CLKOUT should have a minimum pulse width of 300 ns and a
maximum period of 1000 ns. The internal clock, now sourced from CLKOUT, is divided
down by a 2
be set into a known state by using bit STOP. When bit STOP is logic 1, the prescaler is
reset to 0. STOP must be cleared before the prescaler can operate again.
From a stop condition, the first 1 second increment will take place after 32 positive edges
on pin CLKOUT. Thereafter, every 64 positive edges will cause a 1 second increment.
Remark: Entry into test mode is not synchronized to the internal 64 Hz clock. When
entering the test mode, no assumption as to the state of the prescaler can be made.
Operating example:
Repeat 7 and 8 for additional increments.
1. Set EXT_TEST test mode (register Control_1, EXT_TEST is logic 1).
2. Set bit STOP (register Control_1, STOP is logic 1).
3. Set time registers to desired value.
4. Clear STOP (register Control_1, STOP is logic 0).
5. Apply 32 clock pulses to CLKOUT.
6. Read time registers to see the first change.
7. Apply 64 clock pulses to CLKOUT.
8. Read time registers to see the second change.
6
divider chain called prescaler (see prescaler in
Rev. 01 — 21 January 2010
Integrated RTC, TCXO and quartz crystal
Table
55). The prescaler can
PCF2127A
© NXP B.V. 2010. All rights reserved.
50 of 79