psd813f1a-90ut STMicroelectronics, psd813f1a-90ut Datasheet - Page 34

• Manufacturer Part Number: psd813f1a-90ut
• Description: Flash In-system Programmable Isp Peripherals For 8-bit Mcus
• Manufacturer: STMicroelectronics

Preliminary
The
PSD913F1
Functional
Blocks
(cont.)
9.2 PLDs
The PLDs bring programmable logic functionality to the PSD913F1. After specifying the
chip selects or logic equations for the PLDs in PSDsoft, the logic is programmed into the
device and available upon power-up.
The PSD913F1 contains two PLDs: the Decode PLD (DPLD), and the General Purpose
PLD (GPLD). The PLDs are briefly discussed in the next few paragraphs, and in more detail
in sections 9.2.1 and 9.2.2. Figure 11 shows the configuration of the PLDs.
The DPLD performs address decoding for internal components, such as memory,
registers, and I/O port selects.
The GPLD can be used to generate external chip selects, control signals or logic functions.
The GPLD has 19 outputs that are connected to Ports A, B and D.
The AND array is used to form product terms. These product terms are specified using
PSsoft. An Input Bus consisting of 57 signals is connected to the PLDs. The signals are
shown in Table 13. The complement of the 57 signals are also available as input to the AND
array.
Table 13. DPLD and GPLD Inputs
NOTE: The address inputs are A[19:4] in 80C51XA mode.
The Turbo Bit
The PLDs in the PSD913F1 can minimize power consumption by switching off when inputs
remain unchanged for an extended time of about 70 ns. Setting the Turbo mode bit to off
(Bit 3 of the PMMR0 register) automatically places the PLDs into standby if no inputs
are changing. Turbo-off mode increases propagation delays while reducing power
consumption. Refer to the Power Management Unit section on how to set the Turbo Bit.
Additionally, five bits are available in the PMMR2 register to block MCU control signals from
entering the PLDs. This reduces power consumption and can be used only when these
MCU control signals are not used in PLD logic equations.
MCU Address Bus
MCU Control Signals
Reset
Power Down
Port A Input
Port B Input
Port C Input
Port D Inputs
Page Register
Flash Programming Status Bit
Input Source
A[15:0]
CNTL[2:0]
RST
PDN
PA[7-0]
PB[7-0]
PC[7-0]
PD[2:0]
PGR(7:0)
Rdy/Bsy
Input Name
*
of Signals
Number
16
3
1
1
8
8
8
3
8
1
PSD913F1
33