zl50052 Zarlink Semiconductor, zl50052 Datasheet - Page 32

• Manufacturer Part Number: zl50052
• Description: 8 K Channel Digital Switch With High Jitter Tolerance, Single Rate 32 Mbps , And 16 Inputs And 16 Outputs
• Manufacturer: Zarlink Semiconductor

13.0
This section describes the registers that are used in the device.
13.1
Address 0000
The Control Register defines which memory is to be accessed. It initiates the memory block programming mode
and selects the Backplane and Local data rate modes. The Control Register (CR) is configured as follows:
15:13
Bit
12
10
11
9
8
7
6
5
Control Register (CR)
MODE[2:0]
Detailed Register Descriptions
Reserved
Reserved
Reserved
C8IPOL
COPOL
FBDEN
SMPL_
MODE
Name
FBD_
FPW
H
.
Reset
Value
0
0
0
0
0
0
0
0
0
Frame Boundary Discriminator Mode
When set to 111
frequency and high frequency jitter.
When set to 000
frequency jitter only.
All other values are reserved.
These bits are ignored when FBDEN bit is LOW.
Sample Point Mode
When LOW the input bit sampling point is always at the 3/4 bit location. The input bit
fractional delay is programmed in 1/4 bit increments from 0 to 7 3/4 as per the value
of the LIDR0 to LIDR7 and BIDR0 to BIDR7 registers.
When HIGH, the input bit sampling point is programmed to the 3/4, 4/4, 1/4, 2/4 bit
location as per the value of the LIDR0 to LIDR7 and BIDR0 to BIDR7 registers. In
addition the incoming data can be delayed by 0 to 7 bits in 1 bit increments.
See Table 13, Table 14, Table 15 and Table 16 for details.
Reserved
Must be set to 0 for normal operation
Frame Boundary Discriminator Enable
When LOW, the frame boundary discriminator function is disabled.
When HIGH, enables frame boundary discriminator function which allows the
device to tolerate inconsistent frame boundaries, hence improving the tolerance to
cycle-to-cycle variation on the input clock.
Reserved
Must be set to 0 for normal operation
Frame Pulse Width
When LOW, the user must apply a 122 ns frame pulse on FP8i; the FP8o pin will
output a 122 ns wide frame pulse; FP16o will output a 61 ns wide frame pulse.
When HIGH, the user must apply a 244 ns frame pulse on FP8i; the FP8o pin will
output a 244 ns wide frame pulse; FP16o will output a 122 ns wide frame pulse.
Reserved
Must be set to 0 for normal operation
8 MHz Input Clock Polarity
The frame boundary is aligned to the falling or rising edge of the input clock.
When LOW, the frame boundary is aligned to the clock falling edge.
When HIGH, the frame boundary is aligned to the clock rising edge.
Output Clock Polarity
When LOW, the output clock has the same polarity as the input clock.
When HIGH, the output clock is inverted.
This applies to both the 8 MHz (C8o) and 16 MHz (C16o) output clocks.
Table 11 - Control Register Bits
B
B
Zarlink Semiconductor Inc.
, the Frame Boundary Discriminator can handle both low
, the Frame Boundary Discriminator is set to handle lower
ZL50052
32
Description
Data Sheet