FDC37B787QF SMSC [SMSC Corporation], FDC37B787QF Datasheet - Page 195
FDC37B787QF
Manufacturer Part Number
FDC37B787QF
Description
Super I/O Controller with ACPI Support, Real Time Clock and Consumer IR
Manufacturer
SMSC [SMSC Corporation]
Datasheet
1.FDC37B787QF.pdf
(249 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
- Current page: 195 of 249
- Download datasheet (881Kb)
IRQ Mux Control
Register
Default = 0x00
on Vbat POR
NAME
REG INDEX
0XC0 R/W
This register is used to configure the IRQs, including PME,
SCI and SMI.
Bit[0] Serial/Parallel IRQs
0=Serial IRQs are used
1=Parallel IRQS are used
Note 1: This bit does not control the RTC IRQ, SCI or SMI
interrupts. See bits 1,2,7 of this register.
Note 2: If set, the BIOS buffer is disabled. Also, the
SER_IRQ and PCI_CLK pins are disabled, and these pins
function as IRQ15 and IRQ14, respectively.
Note 3: Select IRQ9 below. Select RTC IRQ and SCI
below. Select nSMI through the SMI register.
Bit[1] RTC IRQ Select.
0=RTC IRQ on serial IRQ frame
1=RTC IRQ on IRQx pin
Bit[2] SCI Select
0=SCI is on serial IRQ frame
1=SCI is on IRQx pin
Note: Serial IRQs are not available under V
Bit[3] SCI Polarity Select (EN1)
0=SCI active low
1=SCI active high
Bit[4] SCI Buffer Type (EN1)
0=Push-pull
1=Open drain
Bit[6:5] SCI/PME/IRQ9 Pin select
00=Pin 21 is used for nPME signal.
01=Pin 21 is used for SCI.
10=Pin 21 is used for IRQ9.
11=Reserved
Engineering Note: If bit 5 is set, this overrides the setting
of the IRQ for SCI in Config Register 0x70 of Logical
Device A. See the logic in the SCI section.
Enginreering Note: This bit selects the buffer type of the
pin as follows: if nPME is selected, it is active low OD; if
SCI is selected, the buffer type and polarity are selected
through bits 3 and 4 of this register; if IRQ9 is selected, it
is an active high push-pull output.
Bit[7] SMI Select
0=SMI is on serial IRQ frame (IRQ2)
1=SMI is on nSMI pin
Engineering Note: the polarity and buffer type of the SMI
pin is selected through the GPIO registers (default is active
low open drain).
198
DEFINITION
TR
power.
STATE
Related parts for FDC37B787QF
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
FAST ETHERNET PHYSICAL LAYER DEVICE
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
4-PORT USB2.0 HUB CONTROLLER
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
FDC37C672ENHANCED SUPER I/O CONTROLLER WITH FAST IR
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
COM90C66LJPARCNET Controller/Transceiver with AT Interface and On-Chip RAM
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet: