PSF21150 INFINEON [Infineon Technologies AG], PSF21150 Datasheet - Page 79

• Manufacturer Part Number: PSF21150
• Description: IPAC-X ISDN PC ADAPTER CIRCUIT
• Manufacturer: INFINEON [Infineon Technologies AG]

PSB 21150
PSF 21150
Description of Functional Blocks
F4 Pending Activation
The IPAC-X transmits info 1 towards the network, waiting for info 2.
F5 Unsynchronized
Any signal except info 2 or 4 detected on the S/T interface.
F6 Synchronized
The receiver has synchronized and detects info 2. Info 3 is transmitted to synchronize
the NT.
F7 Activated
The receiver has synchronized and detects info 4. All user channels are now conveyed
transparently to the IOM-2 interface.
To transfer user channels transparently to the S/T interface either the command AR8 or
AR10 has to be issued and TR_STA.FSYN must be “1” (signal from remote side must
be synchronous).
F8 Lost Framing
The receiver has lost synchronization in the states F6 or F7 respectively.
Unconditional States
Loop A Closed (internal or external)
The IPAC-X loops back the transmitter to the receiver and activates by transmission of
info 3. The receiver has not yet synchronized.
For a non transparent internal loop the DIS_TX bit of register TR_CONF2 has to be set
to ’1’.
Loop A Activated (internal or external)
The receiver has synchronized to info 3. Data may be sent. The indication “AIL” is output
to indicate the activated state. If the loop is closed internally and the S/T line awake
detector detects any signal on the S/T interface, this is indicated by “RSY”.
Test Mode - SSP
Single alternating pulses are transmitted to the S/T-interface resulting in a frequency of
the fundamental mode of 2 kHz.
Test Mode - SCP
Continuous alternating pulses are transmitted to the S/T-interface resulting in a
frequency of the fundamental mode of 96 kHz.
Data Sheet
79
2000-07-21