M306V0ME-107FP MITSUBISHI [Mitsubishi Electric Semiconductor], M306V0ME-107FP Datasheet - Page 55

• Manufacturer Part Number: M306V0ME-107FP
• Description: SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
• Manufacturer: MITSUBISHI [Mitsubishi Electric Semiconductor]

Rev. 1.0
Table 2.7.3 Settings of interrupt priority levels
2.7.6 Interrupt Enable Flag (I flag)
2.7.7 Interrupt Request Bit
2.7.8 Interrupt Priority Level Select Bit and Processor Interrupt Priority Level (IPL)
Interrupt priority
level select bit
The interrupt enable flag (I flag) controls the enabling and disabling of maskable interrupts. Setting this
flag to “1” enables all maskable interrupts; setting it to “0” disables all maskable interrupts. This flag is set
to “0” after reset.
The interrupt request bit is set to "1" by hardware when an interrupt is requested. After the interrupt is
accepted and jumps to the corresponding interrupt vector, the request bit is set to "0" by hardware. The
interrupt request bit can also be set to "0" by software. (Do not set this bit to "1").
Set the interrupt priority level using the interrupt priority level select bit, which is one of the component bits
of the interrupt control register. When an interrupt request occurs, the interrupt priority level is compared
with the IPL. The interrupt is enabled only when the priority level of the interrupt is higher than the IPL.
Therefore, setting the interrupt priority level to “0” disables the interrupt.
Table 2.7.3 shows the settings of interrupt priority levels and Table 2.7.4 shows the interrupt levels en-
abled, according to the consist of the IPL.
The following are conditions under which an interrupt is accepted:
· interrupt enable flag (I flag) = 1
· interrupt request bit = 1
· interrupt priority level > IPL
The interrupt enable flag (I flag), the interrupt request bit, the interrupt priority select bit, and the IPL are
independent, and they are not affected by one another.
0
0
0
1
1
1
1
b2 b1 b0
0
0
0
1
0
0
1
1
1
0
1
0
0
1
0
1
1
Level 0 (interrupt disabled)
Level 1
Level 2
Level 3
Level 4
Level 5
Level 6
Level 7
Interrupt priority
level
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
Priority
order
High
Low
Table 2.7.4 Interrupt levels enabled according
IPL
0
0
0
1
1
1
1
0
2
IPL
IPL
0
0
1
0
0
1
1
1
1
IPL
0
1
0
0
1
0
1
1
and ON-SCREEN DISPLAY CONTROLLER
to the contents of the IPL
0
MITSUBISHI MICROCOMPUTERS
Interrupt levels 1 and above are enabled
All maskable interrupts are disabled
Interrupt levels 2 and above are enabled
Interrupt levels 3 and above are enabled
Interrupt levels 4 and above are enabled
Interrupt levels 5 and above are enabled
Interrupt levels 6 and above are enabled
Interrupt levels 7 and above are enabled
M306V0ME-XXXFP
Enabled interrupt priority levels
M306V0EEFP
55