SB82371 Intel Corporation, SB82371 Datasheet - Page 45

• Manufacturer Part Number: SB82371
• Description: 82371FB (PIIX) AND 82371SB (PIIX3) PCI ISA IDE XCELERATOR
• Manufacturer: Intel Corporation

2.2.21.
Address Offset:
Default Value:
Attribute:
The Fast Off Timer indicates (through an SMI) that the system has been idle for a pre-programmed period of
time. When the timer expires, an SMI special cycle is generated. The count time interval is programmable
(via the SMICNTL Register). The granularity of the counter is programmable via the SMICNTL Register.
2.2.22.
Address Offset:
Default Value:
Attribute:
The SMIREQ Register contains status bits indicating which enabled event caused an SMI.
1. The SMIREQ bits are set, cleared, or read independently of each other and independently of the
2. If software attempts to set a status bit to 0 at the same time that the PIIX/PIIX3 is setting it to 1, the bit is
3. Each of the SMIREQ bits is set by the PIIX/PIIX3 in response to the activation of the corresponding SMI
4. When an IRQx signal is asserted, the corresponding IRQx status bit is set to a 1. If the IRQx signal is still
5. If an IRQx is set in level mode and shared by two devices, the IRQ should not be enabled as an SMI#
7:0
Before writing to the FTMR Register, the Fast Off Timer must be stopped via bits [4:3] of the SMICNTL
Register.
Bit
CSMIGATE bit in the SMICNTL Register.
set to 1.
event. If the SMI event is still active when the corresponding SMIREQ bit is set to 0, the PIIX/PIIX3 does
not set the status bit back to a 1 (i.e., there is only one status indication per active SMI event).
active when software sets the corresponding status bit to 0, the status bit is not set back to a 1. The IRQx
may be negated before software sets the status bit to 0. However, If the status bit is set to 0 at the same
time a new IRQx is activated, the status bit remains at 1. This indicates to the SMI handler that a new
SMI event has been detected.
event. The PIIX's SMIREQ bits are essentially set with an edge. When the second IRQ occurs on a
shared IRQ, there is no second edge and the SMI# will not be generated for the second IRQ.
FTMR—FAST OFF TIMER REGISTER (Function 0)
SMIREQ—SMI REQUEST REGISTER (Function 0)
Fast Off Timer Value. Bits [7:0] contain one less than the actual count-down value. Thus, if X
is programmed into this register, the countdown value is X+1. The X+1 value is loaded into the
counter when an enabled system event occurs. When the Fast Off Timer reaches 00h, an SMI
is generated and the timer is re-loaded with the X+1 value. When the Fast Off Timer is
enabled (via the SMICNTL Register), the timer counts down from this value. A read from the
FTMR Register returns the value last written.
A8h
0Fh
Read/Write
AA–ABh
00h
Read/Write
NOTE
NOTE
Description
82371FB (PIIX) AND 82371SB (PIIX3)
45