SB82371 Intel Corporation, SB82371 Datasheet - Page 96

• Manufacturer Part Number: SB82371
• Description: 82371FB (PIIX) AND 82371SB (PIIX3) PCI ISA IDE XCELERATOR
• Manufacturer: Intel Corporation

82371FB (PIIX) AND 82371SB (PIIX3)
Two connectors (primary and secondary) and two drives per connector (master and slave) are supported as
shown in Figure 4.
3.5.1.
The IDE ATA I/O ports are decoded by the PIIX/PIIX3 when enabled in the PCICMD and IDETIM Registers
for function 1. (ATA stands for "AT Attachment"—the specification for AT compatible drive interfaces). The
actual ATA registers are implemented in the drive itself. An access to the IDE registers results in the
assertion of the appropriate chip select for the register. The transaction is then run using compatible timing
and using the IDE command strobes (DIOR#, DIOW#).
For each cable (primary and secondary), there are two I/O ranges; the Command block that corresponds to
the CS1x# chip select, and the control block that corresponds to the CS3x# chip select. The command block
is an 8 byte range while the control block is a 4 byte range. The upper 16 bits of the I/O address are decoded
as all 0s.
Primary Command Block Offset:
Primary Control Block Offset:
Secondary Command Block Offset:
Secondary Control Block Offset:
Table 13 specifies the registers as they affect the PIIX/PIIX3 hardware definition.
96
ATA REGISTER BLOCK DECODE
PIIX/PIIX3
Figure 4. IDE Connector and Drive Nomenclature
01F0h
03F4h
0170h
0374h
Master
(Drive 0)
Master
(Drive 0)
IDECONN
Slave
(Drive 1)
Slave
(Drive 1)
Primary
Connector (P)
Secondary
Connector (S)
ideconn.drw