92HD90B0X5NLGXYAX8 IDT, 92HD90B0X5NLGXYAX8 Datasheet - Page 20

• Manufacturer Part Number: 92HD90B0X5NLGXYAX8
• Description: Interface - CODECs
• Manufacturer: IDT

Specifications of 92HD90B0X5NLGXYAX8

• Rohs: yes
• Part # Aliases: IDT92HD90B0X5NLGXYAX8

92HD98
SINGLE CHIP PC AUDIO SYSTEM, CODEC+MONO SPEAKER AMPLIFIER+CAPLESS HP+LDO
IDT CONFIDENTIAL
©2009 INTEGRATED DEVICE TECHNOLOGY, INC.
Function
Port Presence Detect state change Unsolicited Response
GPIO state change
2.7.
2.8.
2.9.
2.10. AFG D3
2.11. Vendor Specific Function Group Power States D4/D5
AFG D0
AFG D1
AFG D2
2.10.1. AFG D3cold
The AFG D0 state is the active state for the device. All functions are active if their power state (if they
support power management at their node level) has been set to D0.
D1 is a lower power mode where all converter widgets are disabled. Analog mixer and port functions
are active. The part will resume from theD1 to theD0 state within 1 mS.
The D2 state further reduces power by disabling the mixer and port functions. The port amplifiers
and internal references remain active to keep port coupling caps charged and the system ready for a
quick resume to either the D1 or D0 state. The part will resume from the D2 state to the D0 state
within 2mS.
The D3-default state is available for HD Audio compliance. All converters are shut down. Port ampli-
fiers and references are active but in a low power state to prevent pops. Resume times may be lon-
ger than those from D2, but still less than 10mS to meet Intel low power goals. The default power
state for the Audio Function Group after power is applied is D3.
While in AFG D3, the HD Audio controller may be in a D0 state (HD Audio bus active) or in a D3
state (HD Audio bus held in reset with no Bit_Clk, SData_Out, or Sync activity.) The expected behav-
ior is as follows (see the HDA015-B section for more information):
The D3cold power state is the lowest power state available that does not use vendor specific verbs.
While in D3cold, the CODEC will still respond to bus requests to revert to a higher power state (dou-
ble AFG reset, link reset). However, audio processing, port presence detect, and other functions are
disabled. Per the HD Audio bus HDA015-B, the D3cold state is intended to be used just prior to
removing power to the CODEC. Typically, power will be removed within 200mS. However, the codec
may exit from the D3cold state by generating 2, back-to-back, AFG reset events. Resume time from
D3cold is less than 200mS.
The codec introduces vendor specific power states. A vendor defined verb is added to the Audio
Function Group that combines multiple vendor specific power control bits into logical power states
for use by the audio driver. The 2 states defined offer lower power than the 5 existing states defined
in the HD Audio specification and HDA015-B. The Vendor Specific D4 state provides lower digital
power consumption relative to D3cold by disabling HD Audio link responses. Vendor specific D5 fur-
ther reduces power consumption on the digital supply by turning off GPIO drivers, and reduces ana-
log power consumption by turning off all analog circuitry except for reset circuits.
HDA Bus active
Unsolicited Response
20
HDA Bus stopped
Wake Event followed by an unsolicited response
Wake Event followed by an unsolicited response
V 1.2 3/12
92HD98