M25P64-VMF6TP NUMONYX, M25P64-VMF6TP Datasheet - Page 9
![IC FLASH 64MBIT 50MHZ 16SOIC](/photos/7/28/72855/m25p64-vmf6tp_sml.jpg)
M25P64-VMF6TP
Manufacturer Part Number
M25P64-VMF6TP
Description
IC FLASH 64MBIT 50MHZ 16SOIC
Manufacturer
NUMONYX
Series
Forté™r
Datasheet
1.M25P64-VME6TG.pdf
(55 pages)
Specifications of M25P64-VMF6TP
Format - Memory
FLASH
Memory Type
FLASH
Memory Size
64M (8M x 8)
Speed
50MHz
Interface
SPI, 3-Wire Serial
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
16-SOIC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
M25P64-VMF6TP
M25P64-VMF6TPTR
M25P64-VMF6TPTR
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
M25P64-VMF6TP
Manufacturer:
Numonyx
Quantity:
1 000
Company:
Part Number:
M25P64-VMF6TP
Manufacturer:
MICRONEOL84
Quantity:
1 016
Part Number:
M25P64-VMF6TP
Manufacturer:
STM
Quantity:
20 000
Company:
Part Number:
M25P64-VMF6TP-6JBS
Manufacturer:
OKI
Quantity:
270
Company:
Part Number:
M25P64-VMF6TP-N
Manufacturer:
STMicroelectronics
Quantity:
500
Company:
Part Number:
M25P64-VMF6TPBA
Manufacturer:
MICRON
Quantity:
1 001
2
2.1
2.2
2.3
2.4
2.5
Signal description
Serial Data Output (Q)
This output signal is used to transfer data serially out of the device. Data is shifted out on the
falling edge of Serial Clock (C).
Serial Data Input (D)
This input signal is used to transfer data serially into the device. It receives instructions,
addresses, and the data to be programmed. Values are latched on the rising edge of Serial
Clock (C).
Serial Clock (C)
This input signal provides the timing of the serial interface. Instructions, addresses, or data
present at Serial Data Input (D) are latched on the rising edge of Serial Clock (C). Data on
Serial Data Output (Q) changes after the falling edge of Serial Clock (C).
Chip Select (S)
When this input signal is High, the device is deselected and Serial Data Output (Q) is at high
impedance. Unless an internal Program, Erase or Write Status Register cycle is in progress,
the device will be in the Standby Power mode. Driving Chip Select (S) Low selects the
device, placing it in the Active Power mode.
After Power-up, a falling edge on Chip Select (S) is required prior to the start of any
instruction.
Hold (HOLD)
The Hold (HOLD) signal is used to pause any serial communications with the device without
deselecting the device.
During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data
Input (D) and Serial Clock (C) are Don’t Care.
To start the Hold condition, the device must be selected, with Chip Select (S) driven Low.
9/55