20-101-0303 Rabbit Semiconductor, 20-101-0303 Datasheet - Page 106

• Manufacturer Part Number: 20-101-0303
• Description: SMARTSCREEN OP7100 W/TOUCHSCREEN
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0303

• Display Type: STN - Super-Twisted Nematic
• Viewing Area: 121.00mm L x 91.00mm W
• Backlight: CCFL - White
• Dot Pitch: 0.36mm x 0.36mm
• Dot Pixels: 320 x 240 (QVGA)
• Interface: Serial
• Product: Prototyping Accessories
• Processor Type: Z180
• Sram: 128 KB
• Flash: 512 KB
• Number Of I/os: 16
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 10 V to 30 V
• Power Consumption: 4.5 W
• Interface Type: Ethernet
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Display Mode: -
• Dot Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 20-101-0303; 20-101-303; 20-101-303; 316-1175

Interrupt Vectors
Table C-5 presents a suggested interrupt vector map. Most of these
interrupt vectors can be altered under program control. The addresses are
given here in hex, relative to the start of the interrupt vector page, as
determined by the contents of the I-register. These are the default interrupt
vectors set by the boot code in the Dynamic C EPROM.
To “vector” an interrupt to a user function in Dynamic C, use a directive
such as the following.
The above example causes the interrupt at offset 0x10 (Serial Port 1 of the
Z180) to invoke the function
declared with the
106
—
0x00
0x02
0x04
0x06
0x08
0x0A
0x0C
0x0E
0x10
Address
Memory, I/O Map, and Interrupt Vectors
#INT _ VEC 0x10 myfunction
interrupt myfunction() {
}
Table C-5. Interrupt Vectors for Z180 Internal Devices
Refer to the Dynamic C manuals for further details on interrupt
functions.
...
INT0
INT1_VEC
INT2_VEC
PRT0_VEC
PRT1_VEC
DMA0_VEC
DMA1_VEC
CSI/O_VEC
SER0_VEC
SER1_VEC
interrupt
Name
myfunction()
keyword, as shown below.
Available for use.
Used for power-failure detection
Reserved for Development Board (CM7100),
not available for use on CM7200
PRT
PRT
DMA
DMA
Available for programming (CM7200), not
available for use on CM7100
Asynchronous Serial Port Channel 0
Asynchronous Serial Port Channel 1
Timer Channel 0
Timer Channel 1
Channel 0
Channel 1
. The function must be
Description
OP7100