EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 19

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

1.4.3 SFM Module – how to fit a new module
To fit a new SFM Module to the programmer:
1.4.4 SFM Module – declaring the module in a Programming Project
The EQ-SFM-1 and EQ-SFM-V1.2 / V1.3 modules actually use slightly different firmware in the
programmer. It is therefore necessary to specify which SFM Module is fitted in each Programming
Project.
To specify the correct SFM Module in a Programming Project:
In EDS (Development Mode):
In Project Builder:
Important notes:
8
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Make sure the programmer is powered off
Remove all cables from the programmer
Remove the four fixing screws in the side of the programmer case
Carefully slide the lid of the programmer upwards and then off
You can find the existing SFM Module underneath the keypad PCB
Carefully remove the existing SFM Module by applying pressure from underneath at both
sides of the circuit board
Fit the new SFM Module in the same position and orientation as the one you have just take
out (make sure to line up the long red connector on the main PCB to the long red connector on
the SFM module
Push the new SFM Module down gently until it locks into place
Replace the programmer lid
Replace the programmer screws
Open your EDS (*.eds) development project
Select the <Programmer and device> tab
Locate the ‘Special Function Module fitted’ list box
Select the relevant SFM Module which you have fitted to your programmer
Open your Programming Project (*.ppm) project
Select the <Programmer and Project Type> tab
Locate the ‘Special Function Module fitted’ list box
Select the relevant SFM Module which you have fitted to your programmer
Re-compile your project to save the changes
Failure to specify the correct SFM Module can result in erratic operation of the programmer.
If you have existing projects which use the standard EQ-SFM module, these projects will need
to be recompiled for the new EQ-SFM-MAX 1.2 or 1.3 Modules.
the SFM module should pop out of the red connectors
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008