EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 22

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

10 PC Control Software The programmer can be controlled using:
11 EQTools / ISP-PRO
12 Power Supply
13 Voltage range
14 Vpp Voltage
15 DC Power Connector
16 DC Power Connector
17 Max. current through
18 Target SPI
PPM3 MKII Programmer - User Guide - V1.04 - 10
PC requirements
Options
Generator
(jack socket)
(Molex)
programmer
Frequency
PC running Windows 95 / 98 / 2000 / ME / NT4 / XP
There are 3 possible modes for powering the Programmer /
Target System:
On Board +12.0V Vpp Voltage Generator
(Applies +12.0V to RESET pin for Atmel ATtiny HV
programming)
DC Power Connector
DC Power Connector
This refers to the maximum current which the programmer can
supply from the ‘controlled’ power supply.
Max current = 300 mA.
Software SPI algorithm:
( SPI speeds are estimations only due to uneven mark/space
ratio and non-continuous waveforms)
Hardware SPI algorithm (requires firmware 3.04 or
greater):
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
EQTools (as standard)
ASCII Text Communications Mode (as standard)
ISP-PRO (chargeable upgrade)
Programmer controls power to the Target System
Programmer and Target System are independently
powered
Target System powers the Programmer (+5V only)
Device Programming voltage range: 3.0 – 5.0V
Programmer Controlled Power Supply range: 3.0 – 5.0V
Possible Target System voltage range: 3.0 – 5.0V
2.5 mm Jack Socket – Centre Positive
9.0 – 12.0V DC regulated @ 500mA (worst case)
Mates with Power Supply Adaptor supplied with
programmer
DC Power Lead also supplied with programmer if a
customer power supply is to be used.
2-pin pluggable Molex Connector
9.0 – 12.0V DC regulated @ 500mA (worst case)
SLOW SPI: 0 – 490.2 kHz (user selectable)
MEDIUM SPI: 0 – 490.2 kHz (user selectable)
SLOW SPI: 115.2 kHz to 3.6864 MHz (user selectable)
FAST SPI: 115.2 kHz to 3.6864 MHz (user selectable)
SPI speeds > 500kHz require the fitting of the faster
EQ-SFM-MAX V1.2 or V1.3 SFM Modules
th
May 2008
2.3
2.3
4.0
4.4
4.2
11