EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 23

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

19 Target JTAG
20 JTAG Programming
21 I2C Frequency
22 Target UART Speed
23 ISP Headers
24 Frequency generator
25 AVR On-chip
12
Frequency
Modes
output (SCK2)
Oscillator Calibration
With standard ‘SFM Module’ fitted:
The programmer supports a user-defined JTAG frequency:
With ‘SFM-MAX V1.2 or V1.3’ Module fitted:
The programmer supports the following JTAG modes:
The programmer supports a user-defined I2C frequency:
The programmer can support any ISP header by simply
plugging in the relevant ‘EQ-IOCON’ I/O Connector Module.
The currently supported ISP Headers are as follows:
Please refer to the separate manual ‘PPM3 I/O Connector
Modules’ for full details of each module and the connection
mechanisms available.
Programmer can output a configurable square wave frequency
on the SCK2 pin. This is used to clock the Target Device in the
absence of a Target Oscillator.
If the programmer is fitted with either the ‘CALCON’ or ‘EQ-
SFM-V1.3’ module, then it can be used to calibrate the internal
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
SLOW JTAG: 0 – 833 kHz
SLOW JTAG: 0 – 833 kHz
FAST JTAG: approx 1.4 MHz
Single JTAG device connected to programmer
Multiple JTAG devices connected in a JTAG Chain
JTAG ID can be verified for both Atmel AVR and non-
Atmel JTAG devices
JTAG chain validation is also supported
SLOW I2C: 0 – 400 kHz
Supports ISP programming of both 100 kHz and 400
kHz I2C Serial EEPROMs
This is the Communications Speed (BAUD rate) from
the programmer to the Target Device when
communicating via a Boot Loader.
The BAUD rate is configurable from 1,200 to 115
kBaud.
This settings is completely independent from the BAUD
rate settings for the PC communicating with the
programmer.
Atmel 10-way (SPI)
Atmel 6-way (SPI)
Atmel 10-way (JTAG)
Equinox 10-way (SPI+UART)
Fast-connect wire connectors
Frequency range: 167kHz – 1.8432 MHz
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008