EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 70

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

4.4.2 Device Programming Voltage Range
The PPM3 programmer can program devices with a target voltage between the min. and max. values
detailed in the table below. The programmer cannot currently support programming of devices below
3.V. Please contact Equinox directly for further assistance if your Target Voltage is < 3.0V.
1
Important note:
To verify that a particular device can be programmed at a certain Vcc voltage:
PPM3 MKII Programmer - User Guide - V1.04 - 10
#
•
•
•
•
Allowed voltage range for actual programming of devices
Programmer mode
Check the supply / programming voltage parameters for the actual device (IC) in the
manufacturer’s datasheet.
Many devices have two different voltage range versions eg. 2.7 – 6.0V and 4.0 – 6.0V.
Please ensure that you are programming the device within the stated voltage range.
Ensure that you have selected the required Target Vcc Voltage in your EQTools –
Programming Project (*.ppm).
e.g. if you are programming at +3.3V, you must set up this voltage in your Programming
Project. This can be found in the EQTools - Project Builder <Target Vcc> tab.
For most Atmel AVR and AT89S devices, the FLASH and EEPROM Write Times increase as
the Target Voltage decreases. The timings are automatically set for you in your project as
long as you have declared the correct Target Vcc voltage in your project.
th
May 2008
Min
Vcc
3.00
Max
Vcc
5.00
Units
V
59