EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 7

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

Electromagnetic Compatibility (EMC)
Compliance
The ‘PPM3 MK2 Programmer’ is a CE Approved Product. It is designed for use in an ESD controlled
environment i.e. development or production. This means, therefore, that the user must ensure that
there is no possibility of damage from electrostatic discharge (ESD). Since the devices and equipment
to which this product is likely to be connected may well themselves be susceptible to ESD, this should
not pose any difficulty.
For example, if you are handling microcontrollers and EEPROMS etc. then you will already be used to
appropriate precautions, such as the use of anti-static mats, wrist straps and so on. You should treat
your ‘PPM3 MK2 Programmer’ with the same care as you would these types of devices. Always
ensure that you are not yourself carrying a static charge before handling the product. Wearing an
earthed anti-static wrist strap is recommended.
Equinox have taken great care in designing this product to be compliant with the European EMC
directive. When using the equipment be sure to follow the instructions provided. Although RF
emissions are within prescribed limits, care should be taken if you are using the product near to
sensitive apparatus. If you experience any difficulty please refer to Equinox Technical Support.
Warning!
Any damage caused to the programmer by Electrostatic Discharge (ESD) through inadequate
earthing is not covered under the warranty of the product.
vi
ESD Points to remember
•
•
•
•
any programmable device.
same EARTH (0V) potential.
the Target power is ON.
Work in a static-free environment.
Wear an earthed wrist strap when handling either the programmer and/or
Ensure that the PC, programmer and Target system are connected to the
Do NOT plug the ISP cable of the programmer into a Target System when
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008