EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 27

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

1.7.2 Programming Interface to Target Device
The programmer supports the following programming interfaces to the Target Device:
#
1
2
3
4
5
Please refer to the separate manual ‘PPM3 I/O Connector Modules’ for information on which ISP
Header to use for the required programming interface.
16
Programming
Interface
LV SPI
HV SPI (+12V
Vpp)
UART Boot
Loader
JTAG
(Atmel AVR)
I2C
Family
AT89S
AT90S
AT90USB
AT90CAN
AT90PWM
ATmega
ATmega PICO
ATtiny
Zensys
ATtiny
T89C51Rx2
T89C51AC2
T89C51Ix2
T89C51CC01
P89C51Rx2
P89C66xxx
ATmega
AT90USB
AT90CAN
ATmega PICO
AT24Cxxx
AT24HCxxx
AT34Cxxx
Description / Comment
Atmel Low Voltage Serial Programming Mode
Atmel High Voltage Serial Programming Mode
Atmel / Philips UART Boot Loader Interface
Atmel ATmega AVR – JTAG ISP Interface
I2C 2-wire Interface
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Atmel 3-wire SPI interface (SCK, MOSI, MISO )
Target Device RESET
Works at target voltage (no Vpp required)
Atmel 4-wire SPI Interface (SCK, MOSI, MISO, MOSI2)
+12V Vpp is applied to the RESET pin to enter High
Voltage Serial Programming Mode
Requires different connections to Target Device
compared with LV SPI.
Requires all pins of target device to be accessible by
the programmer.
Uses RXD, TXD, PSEN, and Target Device RESET pin
TTL Levels from programmer to Target System
Uses same connector as Atmel JTAG ICE
A chargeable license upgrade is required to enable the
ATmega JTAG ISP libraries.
Supports JTAG Chain Mode programming
There is no dedicated connector for I2C programming
so it is necessary to re-use either an SPI or JTAG
connector for I2C.
The programmers uses the following I/O pins for I2C:
External pull-up resistors (eg. 4k7) are required on the
SDA and SCL lines. These can be fitted on the IO-CON
Module, Test Fixture or Target System.
PPM3 MKII Programmer - User Guide - V1.04 - 10
o SDA (SPI MOSI pin)
o SCL (SPI SCK pin)
th
May 2008