ST62E2XC-EPB/110 STMicroelectronics, ST62E2XC-EPB/110 Datasheet - Page 11

• Manufacturer Part Number: ST62E2XC-EPB/110
• Description: BOARD PROGRAMMING FOR ST625X/6X
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of ST62E2XC-EPB/110

• Contents: Programmer Board
• For Use With/related Products: ST7265x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CAUTION: Connecting the P1 board connector to a serial port of the PC could damage the board.
4.2.2 EPROM Programmer Board with Parallel Interface
Proceed as follows:
1 Power off the PC computer and the EPROM programmer,
2 Using the parallel interface cable, connect the parallel port of the PC (LPT1 or LPT2) to the
3 Power on the PC and the EPROM programmer board,
4 The POWER LED (LD1) lights up, showing that the board is supplied.
Notes: The supplied interface cable has been tested in order to operate properly on most PCs.
4.3 SOFTWARE INSTALLATION
The EPB comes with a CD-ROM that contains the ST6 ToolChain. To install the Windows
Epromer programmer interface for starter kits, EPBs and gang programmers, follow these
steps:
1 Insert the “MCU ON CD” CD-ROM into your CD-ROM drive. The CD-ROM’s autorun feature
will open up a welcome screen on your PC.
If the autorun feature does not work, use the Windows File Manager or Windows Explorer to
browse to the CD-ROM’s root folder, and double-click on Welcome.exe.
2 Select Install Your Development Tools from the list of options. A new screen will appear
listing the different families of STMicroelectronics MCUs.
3 Use your mouse to place the cursor over the ST6 Tools option. Choose ST Tools and ST6
Toolchain from the lists that appear.
4 The install wizard will be launched. Follow the instructions that appear on the screen.
5 Select the program folder that the software will be installed to and click on the next button.
P1 board connector,
Do not use any other cable, especially if it is longer than the one provided by STMicro-
electronics: the board may not operate properly.
The cable should be connected directly to the DB-25 female connector of the PC par-
allel port. This connector is similar to the one installed on the board. Do not insert any
additional cables or switchboxes between the PC and the board: a malfunctioning of
the board may result.
If a dongle is mounted on the PC parallel port, it should not interfere with the program-
ming board. Should you notice a dysfunctioning of the board, remove the dongle and
restart the installation procedure.
EPB - Remote Mode
8
11/39