ST62E2XC-EPB/110 STMicroelectronics, ST62E2XC-EPB/110 Datasheet - Page 30

• Manufacturer Part Number: ST62E2XC-EPB/110
• Description: BOARD PROGRAMMING FOR ST625X/6X
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of ST62E2XC-EPB/110

• Contents: Programmer Board
• For Use With/related Products: ST7265x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

EPB - Stand-Alone Mode
5.4 BLANK CHECKING YOUR MICROCONTROLLER
You may want to check whether the device you’re about to program has not some code on it.
For this, proceed as follows:
1 Select the reference EPROM as the reference component,
2 Remove (if any) the reference EPROM from its socket,
3 Insert into the socket the ST6xxxx MCU to be checked,
4 Set the MASTER/TARGET switch on the TARGET position:
5 Set the PROG/VERIF switch on the VERIF position:
6 Validate your settings by pressing the START key.
The blank checking process begins while the red BUSY LED (LD2) starts flashing.
The LED final status reflects the result of the operation:
5.5 PROGRAMMING YOUR MICROCONTROLLER
To program your microcontroller, proceed as follows:
1 If you are using a Reference MCU, make sure that you have read the appropriate reference
In any case, make sure that the jumpers are properly set in the W1 and W2 jumper banks.
2 Insert the microcontroller to be programmed into the appropriate socket, depending on the
3 If you want to protect the programmed device against further reading, you must specify
30/39
When lit, the green OK LED (LD4) reports a successful end of operation.
When lit, the red ERROR LED (LD3) reports an error.
ALL LEDS on means that the device is protected against reading.
MCU beforehand, and that the appropriate code has been stored in the memory of your
EPB, or
If you are using a reference REPROM, insert it in the appropriate socket, depending on the
type of EPB:
type of EPB.
your choice before you start the programming procedure. The protection will take effect at
the completion of the procedure. A protected device cannot be used for programming or
verifying another device; this is therefore the best method to protect your software against
piracy.
To select the read protect option, set the appropriate jumper in the W1 jumper bank, de-
pending on the type of EPB:
27