C8051F411EK Silicon Laboratories Inc, C8051F411EK Datasheet - Page 169

• Manufacturer Part Number: C8051F411EK
• Description: KIT EVAL FOR C8051F411
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F411EK

• Contents: Evaluation Board, CD-ROM, USB Cable, Batteries and User Guide
• Processor To Be Evaluated: C8051F41x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F411
• Silicon Family Name: C8051F41x
• Kit Contents: LCD Based Evaluation Board, USB Cable, Software CD And Quick-Start Guide
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Silicon Laboratories C8051F41x
• For Use With: 336-1315 - KIT REF DESIGN VOICE RECORD F41X
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1317

When the crystal oscillator is first enabled, the oscillator amplitude detection circuit requires a settling time
to achieve proper bias. Introducing a delay of 1 ms between enabling the oscillator and checking the
XTLVLD bit will prevent a premature switch to the external oscillator as the system clock. Switching to the
external oscillator before the crystal oscillator has stabilized can result in unpredictable behavior. The rec-
ommended procedure is:
Note: Tuning-fork crystals may require additional settling time before XTLVLD returns a valid result.
The capacitors shown in the external crystal configuration provide the load capacitance required by the
crystal for correct oscillation. These capacitors are "in series" as seen by the crystal and "in parallel" with
the stray capacitance of the XTAL1 and XTAL2 pins.
Note: The load capacitance depends upon the crystal and the manufacturer. Please refer to the crystal
data sheet when completing these calculations.
For example, a tuning-fork crystal of 32.768 kHz with a recommended load capacitance of 12.5 pF should
use the configuration shown in Figure 19.1, Option 1. The total value of the capacitors and the stray capac-
itance of the XTAL pins should equal 25 pF. With a stray capacitance of 3 pF per pin, the 22 pF capacitors
yield an equivalent capacitance of 12.5 pF across the crystal, as shown in Figure 19.2.
Important Note on External Crystals: Crystal oscillator circuits are quite sensitive to PCB layout. The
crystal should be placed as close as possible to the XTAL pins on the device. The traces should be as
short as possible and shielded with ground plane from any other traces which could introduce noise or
interference.
Step 1. Force the XTAL1 and XTAL2 pins low by writing 0's to the port latch.
Step 2. Configure XTAL1 and XTAL2 as analog inputs.
Step 3. Release the crystal pins by writing ‘1's to the port latch.
Step 4. Enable the external oscillator.
Step 5. Wait at least 1 ms.
Step 6. Poll for XTLVLD => '1'.
Step 7. Switch the system clock to the external oscillator.
Figure 19.2. 32.768 kHz External Crystal Example
32.768 kHz
22 pF
22 pF
Rev. 1.1
10 M

C8051F410/1/2/3
XTAL1
XTAL2
169