DK-VIDEO-4SGX230N Altera, DK-VIDEO-4SGX230N Datasheet - Page 18

• Manufacturer Part Number: DK-VIDEO-4SGX230N
• Description: VIDEO KIT STRATIX IV EP4SGX230
• Manufacturer: Altera
• Series: Stratix® IVr
• Type: FPGAr

Specifications of DK-VIDEO-4SGX230N

• Contents: Board, Daughter Card, Cables, CD, DVD, Power Supply
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Stratix
• Silicon Core Number: EP4S
• Silicon Family Name: Stratix IV GX
• Rohs Compliant: Yes
• For Use With/related Products: EP4SGX230K
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2602

4–2
Factory Default Switch Settings
Audio Video Development Kit, Stratix IV GX Edition User Guide
f
1
The MAX II device on the board contains a parallel flash loader (PFL) megafunction.
When the board powers up, the PFL reads one of two designs from flash memory and
configures the FPGA. The rotary switch (SW2) controls which design to load. When
the switch is in the 0 position, the PFL loads the design from the factory portion of
flash memory. When the switch is in the 1 position, the PFL loads the design from the
user portion of flash memory.
The development kit includes the MAX II configuration design in the <install
dir>\kits\stratixIVGX_4sgx230_av\examples\max2 directory.
When configuration is complete, the CONF DONE LED (D5) illuminates, signaling
that the Stratix IV GX device configured successfully.
For more information about the PFL megafunction, refer to
Flash Loader with the Quartus II
This section shows the factory switch settings for the Stratix IV GX FPGA
development board.
each switch on the top side of the board.
Figure 4–1. Switch Locations and Default Settings on the Development Board Top
Figure 4–2
bottom side of the board.
shows the switch locations and the default position of each switch on the
Figure 4–1
Software.
shows the switch locations and the default position of
Rotary
Switch
SW2
0
8
User DIP
7
Switch
© November 2009 Altera Corporation
Chapter 4: Development Board Setup
SW3
6
5
AN 386: Using the Parallel
4
3
2
ON
1
Factory Default Switch Settings
OFF = 1
ON = 0