DM300014 Microchip Technology, DM300014 Datasheet - Page 26

• Manufacturer Part Number: DM300014
• Description: BOARD DEMO DSPICDEM 1.1 GEN PURP
• Manufacturer: Microchip Technology

Specifications of DM300014

• Processor To Be Evaluated: PIC30F
• Data Bus Width: 16 bit
• Interface Type: RS-485, CAN, SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

dsPICDEM™ 1.1 Development Board User’s Guide
2.7
DS70099B-page 22
DEBUGGING THE CODE
2.6.4
1. From the Debugger menu, select Program. The Output window (Figure 2-14)
2. Observe the process in the Output window. When “MPLAB ICD 2 Ready”
FIGURE 2-14:
3. Use the Debugger>Reset menu to reset the code, then Debugger>Run to run the
FIGURE 2-15:
The MPLAB ICD 2 In-Circuit Debugger can be used to run, halt and step the code. A
breakpoint can be set to halt the program after the code has executed the instruction
at the breakpoint. The contents of the RAM and registers can be viewed whenever the
processor has been halted.
The MPLAB ICD 2 In-Circuit Debugger uses the following function keys to access the
main debugging functions:
<F5>
<F6>
<F7>
<F9>
In addition, there are more functions available by right clicking on a line of source code.
The most important of these are “Set Breakpoint” and “Run to Cursor.”
displays the program steps as they occur.
displays, the device is programmed and ready to run.
code. LED1 should start blinking and the LCD display should show the text in
Figure 2-15.
Halt
Reset
Single Step
Run
Program the dsPIC30F6014 Device
Advance Information
PROGRAMMING THE dsPIC30F6014 DEVICE
TUTORIAL LCD DISPLAY
D
EVELOPMENT
dsPICDEM 1.1
T
UTORIAL
B
OARD
 2003 Microchip Technology Inc.