M5307C3 Freescale Semiconductor, M5307C3 Datasheet - Page 26

• Manufacturer Part Number: M5307C3
• Description: KIT EVALUATION FOR MCF5307
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: Microprocessorr

Specifications of M5307C3

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: MCF5307
• Interface Type: Ethernet
• For Use With/related Products: MCF5307
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The commands DI, GO, MD, STEP and TRACE are used repeatedly when debugging.
dBUG recognizes this and allows for repeated execution of these commands
with minimal typing. After a command
<ENTER> to invoke the command
command line parameters were provided.
An additional function called the "TRAP
utilize various routines within dBUG. The TRAP 15 handler is discussed at the
end of this chapter.
The operational mode of dBUG is demonstrated
initialization, the board waits for a command-line
terminal. When a proper command
of the two basic modes.
program, the dBUG firmware may or may not be re-entered, depending on the
discretion of the user. For the alternate case, the command
under control of the dBUG firmware, and after command
system returns to command entry mode.
During command
on the command function.
For commands
size, the valid values are:
When no <width> option is provided, the default width is .W, 16-bit.
The core ColdFire® register set is maintained by dBUG.
All control registers on ColdFire® are not readable by the supervisor-
programming
these registers, but caution must be exercised as changes may
useless.
.B
.W
.L
A0-A7
D0-D7
PC
SR
8-bit (byte) access
16-bit (word) access
32-bit (long) access
model, and thus not accessible via dBUG. User code may change
that accept an optional <width> to modify the memory
execution, additional user input may be required depending
Freescale Semiconductor, Inc.
For More Information On This Product,
If the command
Go to: www.freescale.com
again. The command
is entered, the operation continues in one
2-2
15 handler" allows the user program to
is entered, simply press <RETURN> or
causes execution of the user
in Figure 5. After the system
input from
is executed as if no
These are listed below
will be executed
completion, the
render dBUG
the user
access