M5407C3 Freescale Semiconductor, M5407C3 Datasheet - Page 21

• Manufacturer Part Number: M5407C3
• Description: KIT EVAL FOR MCF5407 W/ETHERNET
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: Microprocessorr

Specifications of M5407C3

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MCF5407
• Interface Type: Ethernet
• For Use With/related Products: MCF5407
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Hyper Terminal or similar packages. Then connect as described in 1.9.6, “Connecting the
Terminal.”
Once the connection to the PC is made, you are ready to power-up the PC and run the
terminal emulation software. When you are in the terminal mode, you need to select the
baud rate and the character format for the channel. Most terminal emulation software
packages provide a command known as "Alt-p" (press the p key while pressing the Alt key)
to choose the baud rate and character format. Make sure you select 8 bits, no parity, one
stop bit, see section The Terminal Character Format. Then, select the baud rate as 19200.
Now you are ready to apply power to the board.
Figur 1-3 shows pin assignments for female terminal connector.
Pin assignments are as follows.
Figure 1-4 shows jumper locations.
1. Data Carrier Detect, Output (shorted to pins 4 and 6).
2. Receive Data, Output from board (receive refers to terminal side).
3. Transmit Data, Input to board (transmit refers to terminal side).
4. Data Terminal Ready, input (shorted to pin 1 and 6).
5. Signal Ground.
6. Data Set Ready, Output (shorted to pins 1 and 4).
7. Request to Send, input.
8. Clear to send, output.
9. Not connected.
Figure 1-3. Pin assignment for female P4 (Terminal) connector.
Freescale Semiconductor, Inc.
5
Chapter 1. M5407C3 Board
9
6
1
Installation And Setup
1-9