ST7MC2M9 STMicroelectronics, ST7MC2M9 Datasheet - Page 48

• Manufacturer Part Number: ST7MC2M9
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC,BRUSHLESS MOTOR CONTROL, 5 TIMERS, SPI, LINSCI(TM)
• Manufacturer: STMicroelectronics

Specifications of ST7MC2M9

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and by-pass for external clock, clock security system.
• Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Main Clock Controller With: Real time base, Beep and Clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, external clock input, PWM and pulse generator modes
• 8-bit Pwm Auto-reload Timer With: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

ST7MC1xx/ST7MC2xx
EXTERNAL INTERRUPT CONTROL REGISTER (EICR) (Cont’d)
- ei0 (port D6..4)
- ei0 (port D3..1)
These 2 bits can be written only when I1 and I0 of
the CC register are both set to 1 (level 3).
48/309
1
IS31 IS30
IS31 IS30
0
0
1
1
0
0
1
1
0
1
0
1
0
1
0
1
Falling edge only
Rising edge only
Falling edge &
IPA bit =0
low level
External Interrupt Sensitivity
External Interrupt Sensitivity
Falling edge & low level
Rising and falling edge
Rising and falling edge
Falling edge only
Rising edge only
Falling edge only
Rising edge only
Rising edge
& high level
IPA bit =1
Bit 0 = IPA Interrupt polarity for port D
This bit is used to invert the sensitivity of the port D
[6:4] external interrupts. It can be set and cleared
by software only when I1 and I0 of the CC register
are both set to 1 (level 3).
0: No sensitivity inversion
1: Sensitivity inversion