ST72321AR6-Auto STMicroelectronics, ST72321AR6-Auto Datasheet - Page 102

• Manufacturer Part Number: ST72321AR6-Auto
• Description: 8-bit MCU for automotive with 32 Kbyte Flash, 10-bit ADC, timers, SPI, SCI and I2C interfaces
• Manufacturer: STMicroelectronics

Specifications of ST72321AR6-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years
• Clock Sources: crystal/ceramic resonator oscillators, internal RC oscillator and bypass for external clock
• 4 Power Saving Modes: Halt, Active Halt, Wait and Slow

16-bit timer
13.3.2
Note:
102/243
External clock
The external clock (where available) is selected if CC0 = 1 and CC1 = 1 in the CR2 register.
The status of the EXEDG bit in the CR2 register determines the type of level transition on
the external clock pin EXTCLK that will trigger the free running counter.
The counter is synchronized with the falling edge of the internal CPU clock.
A minimum of four falling edges of the CPU clock must occur between two consecutive
active edges of the external clock; thus, the external clock frequency must be less than a
quarter of the CPU clock frequency.
Figure 43. Counter timing diagram, internal clock divided by 2
Figure 44. Counter timing diagram, internal clock divided by 4
Figure 45. Counter timing diagram, internal clock divided by 8
The MCU is in reset state when the internal reset signal is high; when it is low the MCU is
running.
TIMER OVERFLOW FLAG (TOF)
TIMER OVERFLOW FLAG (TOF)
TIMER OVERFLOW FLAG (TOF)
COUNTER REGISTER
COUNTER REGISTER
COUNTER REGISTER
INTERNAL RESET
INTERNAL RESET
INTERNAL RESET
TIMER CLOCK
CPU CLOCK
TIMER CLOCK
TIMER CLOCK
CPU CLOCK
CPU CLOCK
Doc ID 13829 Rev 1
FFFC
FFFC
FFFD FFFE FFFF 0000 0001 0002 0003
FFFD
FFFD
0000
0001
ST72321xx-Auto
0000