T89C51CC02CA-TDSIM Atmel, T89C51CC02CA-TDSIM Datasheet - Page 47

• Manufacturer Part Number: T89C51CC02CA-TDSIM
• Description: IC 8051 MCU FLASH 16K 24SOIC
• Manufacturer: Atmel
• Series: AT89C CANr

Specifications of T89C51CC02CA-TDSIM

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: CAN, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 20
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 24-SOIC (7.5mm Width)
• For Use With: AT89STK-06 - KIT DEMOBOARD 8051 MCU W/CAN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: T89C51CC02CATDSIM

In-System
Programming (ISP)
Flash Programming and
Erasure
4126L–CAN–01/08
With the implementation of the User Space (FM0) and the Boot Space (FM1) in Flash
technology the T89C51CC02 allows the system engineer the development of applica-
tions with a very high level of flexibility. This flexibility is based on the possibility to alter
the customer program at any stages of a product’s life:
•
•
Note:
This ISP allows code modification over the total lifetime of the product.
Besides the default Bootloaders Atmel provide customers all the needed Application-
Programming-Interfaces (API) which are needed for the ISP. The API are located in the
Boot memory.
This allow the customer to have a full use of the 16-Kbyte user memory.
There are three methods for programming the Flash memory:
•
•
•
Figure 18. Flash Memory Mapping
Before mounting the chip on the PCB, FM0 flash can be programmed with the
application code. FM1 is always preprogrammed by Atmel with a bootloader (chip
can be ordered with CAN bootloader or UART bootloader).
Once the chip is mounted on the PCB, it can be programmed by serial mode via the
CAN bus or UART.
The Atmel bootloader located in FM1 is activated by the application. Low level API
routines (located in FM1)will be used to program FM0. The interface used for serial
downloading to FM0 is the UART or the CAN. API can be called also by user’s
bootloader located in FM0 at [SBV]00h.
A further method exist in activating the Atmel boot loader by hardware activation.
See the Section “Hardware Security Byte”.
The FM0 can be programmed also by the parallel mode using a programmer.
[SBV]00h
1. The user can also program his own bootloader in FM1.
3FFFh
0000h
Flash Memory
16K Bytes
Custom
Bootloader
FM0
F800h
FM1 Mapped between F800h and FFFFh
when API Called
2K Bytes IAP
Bootloader
FM1
AT/T89C51CC02
(1)
FFFFh
47