DF36054FPJV Renesas Electronics America, DF36054FPJV Datasheet - Page 341

• Manufacturer Part Number: DF36054FPJV
• Description: MCU 3/5V 32K J-TEMP PB-FREE 64-L
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of DF36054FPJV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SSU
• Peripherals: PWM, WDT
• Number Of I /o: 45
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

15.3.7
TXPR sets transmit pending (CAN bus arbitration wait) for the transmit message that is stored in a
Mailbox. Setting the corresponding bit in TXPR to 1 enables a message to be transmitted. Writing
0 to the bit in TXPR is ignored.
Bit
7 to 4
3
2
1
0
Bit Name
—
MB3
MB2
MB1
—
Transmit Pending Register (TXPR)
Initial
Value
All 0
0
0
0
0
R/W
—
R/W
R/W
R/W
—
Description
Reserved
These bits are always read as 0.
[Setting condition]
When the corresponding MBCR bit for a mailbox is 0, the
corresponding bit in TXPR is set to 1
(n = 3 to 1)
[Clearing conditions]
If the message is not transmitted successfully, the MBn
bit is not cleared to 0. If any of these MB bits in TXPR are
cleared to 0, the EMPI bit in TCIRR1 is set to 1. The
TinyCAN automatically attempts retransmission as long
as the DART bit in the message control of the
corresponding Mailbox is not set to 1 or the
corresponding bit in TXCR is not set to 1.
Note:
Reserved
This bit is always read as 0. This bit is relevant to the
receive-only Mailbox, and its value cannot be changed.
When message transmission has completed
successfully (TXACKn set)
When transmission cancellation for an untransmitted
message has finished (ABACKn set)
When a transmission cancellation request has
occurred during message transmission, and an error
occurs or arbitration is lost on the CAN bus (ABACKn
set)
When a transmit error or arbitration loss occurred with
the corresponding DART bit for a message being
transmitted set to 1
Section 15 Controller Area Network for Tiny (TinyCAN)
When the MBn bit in MBCR is set to 1, the
TinyCAN does not transmit a message even if
the MBn bit in TXPR is set to 1. To clear the
MBn bit in TXPR to 0, set the MBn bit in TXCR
to 1 beforehand.
Rev. 4.00 Mar. 15, 2006 Page 307 of 556
REJ09B0026-0400