HD64F3337YCP16V Renesas Electronics America, HD64F3337YCP16V Datasheet - Page 545

• Manufacturer Part Number: HD64F3337YCP16V
• Description: MCU 3/5V 60K PB-FREE 84-PLCC
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300r

Specifications of HD64F3337YCP16V

• Core Size: 8-Bit
• Program Memory Size: 60KB (60K x 8)
• Oscillator Type: Internal
• Core Processor: H8/300
• Speed: 16MHz
• Connectivity: Host Interface, I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 84-PLCC
• No. Of I/o's: 74
• Ram Memory Size: 1KB
• Cpu Speed: 16MHz
• No. Of Timers: 6
• No. Of Pwm Channels: 2
• Digital Ic Case Style: PLCC
• Controller Family/series: H8/300
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

21.3.2
When set to user programming mode, the H8/3337SF can erase and program its flash memory by
executing a user program. On-board updates of the on-chip flash memory can be carried out by
providing an on-board circuit for supplying programming data, and storing an update program in
part of the program area.
To select user programming mode, start up in a mode that enables the on-chip flash memory
(mode 2 or 3). In user programming mode, the on-chip supporting modules operate as they
normally would in mode 2 or 3, except for the flash memory.
The flash memory cannot be read while the SWE bit is set to 1 in order to perform programming
or erasing, so the update program must be executed in on-chip RAM or external memory.
User Programming Mode Execution Procedure (Example): Figure 21.11 shows the execution
procedure for user programming mode when the on-board update routine is executed in RAM.
Note: Start the watchdog timer to prevent over-erasing due to program runaway, etc.
User Programming Mode
Figure 21.11 User Programming Mode Operation (Example)
The transfer program (and on-board update
program as required) is written in flash
memory ahead of time by the user.
update routine (update flash memory)
Branch to flash memory on-board
Transfer on-board update routine
Execute flash memory on-board
Branch to application program
Set MD
update routine in RAM
in flash memory
Start from reset
1
and MD
into RAM
0
to 10 or 11
515