M30624FGAFP#U3 Renesas Electronics America, M30624FGAFP#U3 Datasheet - Page 370

• Manufacturer Part Number: M30624FGAFP#U3
• Description: IC M16C MCU FLASH 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30624FGAFP#U3

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 20K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: 867-1000 - KIT QUICK START RENESAS 62PM3062PT3-CPE-3 - EMULATOR COMPACT M16C/62P/30P
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Timer B
2.3.7 Precautions for Timer B (pulse period/pulse width measurement mode)
(1) The timer Bi interrupt request bit goes to “1” when an effective edge of a measurement pulse
(2) If the timer overflow occurs simultaneously with the input of a measurement pulse, and if the
(3) When reset, the timer Bi overflow flag goes to “1”. This flag can be set to “0” by writing to the
(4) Use the timer Bi interrupt request bit to detect only overflows. Use the timer Bi overflow flag
(5) When the first effective edge is input after a count is started, an indeterminate value is trans-
(6) The value of the counter is indeterminate at the beginning of a count. Therefore, the timer Bi
(7) If changing the measurement mode select bits are set after a count is started, the timer Bi
(8) If the input signal to the TBi
(9) For pulse width measurement, pulse widths are successively measured. Use software to
is input or timer Bi is overflowed. The factor of interrupt request can be determined by use of
the timer Bi overflow flag within the interrupt routine.
interrupt factor cannot be determined from the timer Bi overflow flag, connect the timers and
count the number of overflows.
timer Bi mode register when the count start flag is “1”.
only to determine the interrupt factor within the interrupt routine.
ferred to the reload register. At this time, timer Bi interrupt request is not generated.
overflow flag may go to “1” and timer Bi interrupt request may be generated during the inter-
val between a count start and an effective edge input.
interrupt request bit goes to “1”. Note that the timer Bi interrupt request bit does not change if
the same value as before is written to the measurement mode select bits.
performed in some cases. It is recommended to see that measurements fall within a specific
range by use of software.
check whether the measurement result is an “H” level width or an “L” level width.
IN
pin is affected by noise, precise measurement may not be
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M16C / 62A Group
Mitsubishi microcomputers
2-51