ATMEGA8HVD-4MX Atmel, ATMEGA8HVD-4MX Datasheet - Page 93

• Manufacturer Part Number: ATMEGA8HVD-4MX
• Description: MCU AVR 8K FLASH 2.1-8V 4MHZ QFN
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA8HVD-4MX

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 4MHz
• Peripherals: POR, WDT
• Number Of I /o: 5
• Program Memory Size: 8KB (4K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 2.4 V
• Data Converters: A/D 1x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 18-MLF® Exposed Pad (Staggered Leads), DFN
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Connectivity: -

17.6.1
17.6.2
8052B–AVR–09/08
Analog Input Circuitry
Analog Noise Canceling Techniques
Note that the ADC will not be automatically turned off when entering sleep modes other than
Idle mode. The user is advised to write zero to ADEN before entering such sleep modes to
avoid excessive power consumption.
The analog input circuitry is illustrated in
subjected to the pin capacitance and input leakage of that pin, regardless of whether that
channel is selected as input for the ADC. When the channel is selected, the source must drive
the S/H capacitor through the series resistance (combined resistance in the input path).
The ADC is optimized for analog signals with an output impedance of approximately 10 kΩ or
less. If such a source is used, the sampling time will be negligible. If a source with higher
impedance is used, the sampling time will depend on how long time the source needs to
charge the S/H capacitor, which can vary widely. The user is recommended to only use low
impedant sources with slowly varying signals, since this minimizes the required charge trans-
fer to the S/H capacitor.
Signal components higher than the Nyquist frequency (f
distortion from unpredictable signal convolution. The user is advised to remove high frequency
components with a low-pass filter before applying the signals as inputs to the ADC.
Figure 17-4. Analog Input Circuitry
Digital circuitry inside and outside the device generates EMI which might affect the accuracy of
analog measurements. If conversion accuracy is critical, the noise level can be reduced by
applying the following techniques:
1. Keep analog signal paths as short as possible. Make sure analog tracks run over the
2. Use the ADC noise canceler function to reduce induced noise from the CPU.
3. If any port pins are used as digital outputs, it is essential that these do not switch while
another interrupt wakes up the CPU before the ADC conversion is complete, that inter-
rupt will be executed, and an ADC Conversion Complete interrupt request will be
generated when the ADC conversion completes. The CPU will remain in active mode
until a new sleep command is executed.
analog ground plane, and keep them well away from high-speed switching digital
tracks.
a conversion is in progress.
ADCn
I
IH
I
IL
TBD kW
Figure 17-4
TBD kW
ATmega4HVD/8HVD
An analog source applied to ADCn is
ADC
/2) should not be present to avoid
V
CC
/2
C
S/H
= TBD pF
93