5M240ZT100C5N Altera, 5M240ZT100C5N Datasheet - Page 98

• Manufacturer Part Number: 5M240ZT100C5N
• Description: IC CPLD FLASH, 192, 7.5NS, 118.3MHZ, TQFP-100
• Manufacturer: Altera
• Series: MAX Vr

Specifications of 5M240ZT100C5N

• Cpld Type: FLASH
• No. Of Macrocells: 192
• No. Of I/o's: 79
• Propagation Delay: 7.5ns
• Global Clock Setup Time: 4.6ns
• Frequency: 118.3MHz
• Supply Voltage Range: 1.71V To 1.89V
• Rohs Compliant: Yes
• Programmable Type: In System Programmable
• Delay Time Tpd(1) Max: 7.5ns
• Voltage Supply - Internal: 1.71 V ~ 1.89 V
• Number Of Logic Elements/blocks: 240
• Number Of Macrocells: 192
• Number Of Gates: -
• Number Of I /o: 79
• Operating Temperature: 0°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 100-TQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6–4
MAX V Device Handbook
JTAG Block
f
f
For more information about JTAG BST, refer to the
MAX V Devices
If you issue either the USER0 or USER1 instruction to the JTAG test access port (TAP)
controller, the MAX V JTAG block feature allows you to access the JTAG TAP
controller and state signals. The USER0 and USER1 instructions bring the JTAG
boundary-scan chain (TDI) through the user logic instead of the boundary-scan cells
(BSCs) of MAX V devices. Each USER instruction allows for one unique user-defined
JTAG chain into the logic array.
Parallel Flash Loader
MAX V devices have the ability to interface JTAG to non-JTAG devices and are
suitable to use with the general flash memory devices that require programming
during the in-circuit test. You can use the flash memory devices for FPGA
configuration or be part of the system memory. In many cases, you can use the
MAX V device as a bridge device that controls configuration between FPGA and flash
devices. Unlike ISP-capable CPLDs, bulk flash devices do not have JTAG TAP pins or
connections. For small flash devices, it is common to use the serial JTAG scan chain of
a connected device to program the non-JTAG flash device but this is slow, inefficient,
and impractical for large parallel flash devices. Using the MAX V JTAG block as a
parallel flash loader (PFL) with the Quartus II software to program and verify flash
contents provides a fast and cost-effective means of in-circuit programming during
testing.
For more information about PFL, refer to the
Guide.
chapter.
Chapter 6: JTAG and In-System Programmability in MAX V Devices
Parallel Flash Loader Megafunction User
JTAG Boundary-Scan Testing for
IEEE Std. 1149.1 Boundary-Scan Support
December 2010 Altera Corporation